Soundking DX20 Digital Mixing Console User Manual
- June 10, 2024
- Soundking
Table of Contents
Soundking DX20 Digital Mixing Console
IMPORTANT SAFETY SYMBOLS
WARNING: Describes precautions that should be observed to prevent the danger
of injury or death to the operator.
CAUTION: Describes precautions that should be observed to prevent danger of
the apparatus.
IMPORTANT SAFETY INSTRUCTIONS
-
Read these instructions.
-
Keep these instructions.
-
Heed all warning.
-
Follow all instructions.
-
Water & Moisture
The apparatus should be protected from moisture and rain, can not used near water, for example: near bathtub, kitchen sink or a swimming pool, etc. -
Heat
The apparatus should be located away from the heat source such as radiators, stoves or other appliances that produce heat. -
Ventilation
Do not block areas of ventilation opening. Failure to do could result in fire. Always install accordance with the manufacturer’s instructions. -
Object and Liquid Entry
Objects do not fall into and liquids are not spilled into the inside of the apparatus for safety. -
Power Cord and Plug
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety.
If the provided plug does not fit into your outlet, refer to electrician for replacement. -
Power Supply
The apparatus should be connected to the power supply only of the type as marked on the apparatus or described in the manual. Failure to do could result in damage to the product and possibly the user.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. -
Fuse
To prevent the risk of fire and damaging the unit, please use only of the recommended fuse type as described in the manual. Before replacing the fuse, make sure the unit turned off and disconnected from the AC outlet. -
Electrical Connection
Improper electrical wiring may invalidate the product warranty. -
Cleaning
Clean only with a dry cloth. Do not use any solvents such as benzol or alcohol. -
Servicing
Do not implement any servicing other than those means described in the manual. Refer all servicing to qualified service personnel only. -
Only use accessories/attachments or parts recommended by the manufacturer.
PANEL
SPECIFICATION
Input channel | 20 |
---|---|
Bus | 16 |
Stereo bus | 1 |
Effect | 2 modulation, 2 delay, 2 reverb, 2 GEQ |
DCA group | 6 |
Mute group | 2 |
Self-defined key | Support |
Self-defined layer | Support |
Sampling rate | 24bit/48kHz |
Local mic input | 12 x XLR+4xCOMBO |
Local digital input | 1 x S/PDIF |
Local output | BxXLR |
Local digital output | 1xAES/EBU |
Monitor output | 2x XLR |
Earphone output | 1×1/4″ TRS |
Mic amplifier | 16 ch Class A analog amplifier |
Fader | Bx110mm channel,1x110mm main channel |
Screen | 7″ 1024×600 |
RS485 port | Support |
Power supply | AC 100-240V 50/60Hz |
Dimension | 470. 3353147. 3mm |
Net weight | 6.5kg |
SIGNAL FLOW DIAGRAM
-
Gain knob: Adjusts the gain of the corresponding input channel in the range 0-60dB.
-
Screen: Edit and control the mixer via the touch screen.
-
Function key
Setup system function
FX effect
A, B, C, D self-defined function
VIEW -
Adjust parameter knob: Operates with a touch screen to adjust parameters.
-
16 level meter: display main output level.
-
Play key: Control MP3 playback, pause, previous, next and recording.
-
Power supply button .
-
USB2. 0: You can insert a U-disk to play songs, import and export scenes, etc.
-
Headphone: Headphone output connector and volume control knob.
-
Channel fader: with SEL, SOLO, MUTE, 8 level meter and motorized fader.
-
Layer control key
SENDS fast send
IN1 -8 channel 1 to 8
IN9 16 channel 9 to 16
IN ST DCA stereo input and DCA group
BUS bus channel
USER1, USER2 user- defined
VIEW -
Master channel fader: with SEL, SOLO, MUTE and motorized fader.
-
Mute group key.
-
Copy and paste button: Copy between channels, quickly copy the parameters of one channel to another.
REAR PANEL
- Outputs 1-8: 8 XLR output interface for analog signals to external devices via XLR connection cables. Outputs 7-8 output the master channel signal by default.
- Input 1-16: 16 input interface for connecting a line or microphone to an audio signal source.
- USB2.0: same function as front panel USB interface.
- Power supply: input 24V DC power supply interface.
- Monitor: output stereo monitor signal.
- AES/EBU: AES/EBU digital signal output via XLR cable.
- S/PDIF: S/PDIF digital input and output.
- RS-485: External control of the mixer via RS-485 protocol.
- Expansion slot: Multi-track recording card interface.
DIMENSION DRAWING
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>