scancool SD 181 BE Beverage Fridge User Manual

scancool SD 181 BE Beverage Fridge

Please read these instructions completely before operating the units.

SAFETY PRECAUTIONS

• To ensure proper use, please thoroughly study these SAFETY PRECAUTIONS before operating the Unit.

• The purpose of the safety precautions in this manual is to ensure safe and correct use of the unit to minimize risks that could cause serious damage and injury to you or other persons. The safety precautions are divided into WARNINGS and CAUTIONS. Cases, where improper handing of the unit could lead to death or serious

• injury, are listed under the ‘)1,.WARNING” heading. However, the cases listed under the:!:hCAUTION” heading could also lead to serious results. To ensure the safety, adhere strictly to both types of safety precautions.

• Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

• This appliance is not intended for use by persons(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

• Do not damage the refrigerant circuit.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been
  given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
  not be made by children without supervision.

• If the supply cord is damaged, ii must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

• When disposing of the appliance, do so only at an authorized waste disposal centre. Do not expose to flame.

•  Warning: The lamp must not be replaced by the user! If the lamp is damaged, contact the customer helpline for assistance.

• The A-weighted emission sound pressure level is below 70 dB(A)

• The appliance shall be disconnected from its power source during cleaning or maintenance and when replacing parts.

• WARNING Improper handling of the unit could lead lo death or serious injury.

• CAUTION Improper handling of the unit could lead to serious results depending on the circumstances.

PRECAUTIONS FOR INSTALLATION

WARNING
Installation should be performed only by the dealer or a qualified expert. Attempting to install the unit yourself could result in waler leakage, refrigerant leakage, electrical shock, or fire.

PRECAUTIONS FOR USE

HOW TO USE

• BEFORE USE
  Remove shipping package, tape, etc, and leave doors open. Ventilate for a while.

• The unit is cleaned before shipment. However, clean the compartment interior after delivery.

• Please insert power supply plug into the wall outlet ,single-phase to correct voltage.

• Allow the unit to operate for about l hour to cool the compartment before placing items in the cooler.

WAH 5 MINUTES OR MORE BEFORE RE-STARTING
Restarting the unit immediately after it has been turned oft may cause fuses to blow and activate the circuit-breaker, the compressor may be overloaded, and/or other damage may occur.

TEMPERATURE ADJUSTMENT
For the display cooler, the interior temperature will be kept at 0-10° Cat a thermostat temperature setting of 4-5. If the ambient temperature is extremely high or there are a lot of contents inside the
cooler, then the temperature may rise. Therefore, the thermostat setting would need to be increased. If the ambient temperature is very low or there is very few contents in the cooler, then the thermostat setting can be reduced to prevent the internal temperature going below 0° C. Very low temperatures inside the cooler may cause the evaporator to ice up.

DRAIN TRAY

• Defrosting is performed automatically and drain water is collected in the drain tray.
• Water in the drain tray is evaporated automatically. In humid environments, there will be a large amount of water in the drain tray, so please throw away drain water once a day.

EFFICIENT USE

• To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short a time as possible.
• Please install the unit in a place which is well-ventilated.

SHELF HEIGHT ADJUSTMENT
The shelf height can be adjusted.
Arrange the shelves in accordance with the dimensions of the items to be placed in the cooler.

PLACING ITEMS IN THE SHOWCASE
This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items will not be adequately refrigerated. Pay attention to the following points:

• Do not let items obstruct the cold air inlet and suction outlet.
• Place items so that they do not protrude from the shelves. The gap between the shelves and the door is used for circulation of cold air.
• Place items evenly on all shelves.

CLIMATE CLASS

• 320C±2’C on appliances of climatic class O, 1 or 8
• 430C ±20C on appliances of climatic class 5 or 7

CLEANING

WARNING
To prevent any electrical shock hazards or injury by rotating circulation fan, always disconnect the power cord plug from the wall outlet before cleaning.

EXTERIOR AND COOLER COMPARTMENT
Wipe with a soft, dry cloth. If very soiled, wipe with a cloth that has been moistened with a detergent
Then wipe with a cloth that has been dipped in water.

WARNING: Do not splash water directly onto the cooler and do not wash with water. Short -circuit and electrical shock could result.

Clean the cooler regularly to keep it clean at all times.
Never use polishing powder. soap powder. benzine, oil or hot water as these will damage the painting and plastic components.

CHECKS
To ensure the safety, perform the following checks after cleaning.

• 1s the power cord plug firmly inserted into a dedicated wall outlet? Confirm that the plug is not abnormally hot.
• check the power cord for cracks and damage. Should the slightest irregularity be observed, contact the dealer from whom you purchased this unit or our custome~s service.

IN CASE OF THE FOLLOWING

1. POWER FAILURE
   Keep opening and closing of the door to a minimum.
   Avoid placing new items in the cooler as this will raise the temperature inside the compartment.

2. WHEN NOT USED FOR A LONG PERIOD
   Remove all items from the compartment and disconnect the power cord plug from the wall outlet.
   Clean the compartment interior and wipe away all water.
   To prevent mold formation and bad smell, leave the door open to dry the compartment completely.

3. TRANSPORTATION
   Disconnect the power cord plug from the wall outlet.
   When moving the cooler, make sure that the feet do not damage the power cord.
   Do not let the feet hit against floor steps, thresholds, etc.

4. TEMPORARY STORAGE
   Affix a piece of wood, etc. Between the door and main unit lo prevent complete closing of the door.
   Make sure not to store the unused cooler at a location where children play.
   Should a child enter the compartment and the door is closed, the child may not be able to open the door from the inside .

BEFORE REQUESTING SERVICE

Please check the following items if you encounter problems with the unit. If the problem continues after taking the proper remedial actions, disconnect the power cord plug from the wall outlet.
Transfer the items stored in the cooler to a box or other container. Then contact the dealer from whom you purchased this unit and be ready to provide information as listed in “REQUIRED INFORMATION” below.

CAUTION
To prevent any electrical shock hazards, do not disconnect the power cord plug from the wall outlet with wet hands.

Light source in this product is replaceable only by a professional.

BEFORE REQUESTING SERVICE

REQUIRED INFORMATION

1. Nature of malfunction (as accurately as possible)
2. Product number }
3. Serial number
4. Customer”s name, address,phone number
5. Year and date of purchase

UK
Access to professional repair, such as internet webpages, addresses, contact details.
Model no: SD 181 BE

Aftersales service station list

EU DECLARATION OF CONFORMITY

Ref. Ares In accordance with EN ISO 17050-1:2004

Scandomestic A/S Linåvej 20

8600 Silkeborg Denmark

This declaration of conformity is issued under the sole responsibility of the manufacturer (or installer):| Scandomestic A/S Linåvej 20

8600 Silkeborg Denmark

Object of the declaration (identification of product allowing traceability. It may include a colour image of sufficient clarity to enable the identification of the product, where appropriate.)

Product: Commercial Cooler Brand: Scancool

Colour: Black

Model name: SD 181 BE

|
The object of the declaration described in point 4 is in conformity with the relevant Union harmonisation legislation:| EN 61000-3-2
References to the relevant harmonised standards used, or references to the specifications in relation to which conformity is declared:| IEC 60335-2-89:2010+A1:2012+A2:2015, IEC 60335-1:2010+A1:2013, EN 60335-2-

89:2010+A1:2016+A2:2017, EN 60335-

1:2012+A11:2014+A13:2017+A1:2019 + A14:2019+A2:2019, EN 62233:2008, Machine Directive 2006/42/EC, IEC 60335-2-89:2019, IEC 60335-1:2010, COR1:2010, COR2:2010, AMD1:2013, COR1:2014, AMD2:2016, COR1:2016, 2011/65/EU, 2015/863, 2019/2018, 2017/1369, 2019/2024, 2009/125/EC

Where applicable: the notified body … (name, number)… performed … (description of intervention)… and issued the certificate:| RoHS 2011/65/EU + 2015/863
Additional information:| Display Cooler

References

• Scandomestic | Scandomestic.dk
• Scandomestic | scandomestic.dk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>