BROAN 4037767 In-Wall Dehumidifier 2×4 Wall Mounting Bezel Kit Installation Guide
- June 4, 2024
- Broan
Table of Contents
BROAN 4037767 In-Wall Dehumidifier 2×4 Wall Mounting Bezel Kit
Parts Included
- Foam Tape – 4″ Long (x6)
- Foam Tape – 24″ Long (x2)
- Wall Bezel
- Screw A – Wood Screws (x5)
- Screw B – Sheet Metal Screws (x5)
- Plastic Grommet / Drain Hose Bushing – May not be needed
Tools Required
- Drill / Screwdriver
- Drywall Saw
- Bit Extender (optional)
CAUTION!
TURN OFF BREAKER BEFORE INSTALLATION.
- Step 1. Install Foam Tape to Bezel Kit Identify the front side of the bezel kit by locating the semi-circular cutouts along the inside edge. Install 4″ foam tape to the front as shown. Do not cover holes for fastening. Install 24″ foam tape to the back as shown. Do not cover holes for fastening.
- Step 2. Prepare Wall for Install Cut a hole in the drywall 14.5″ wide (stud to stud) and 32.75″ tall. Route electrical wiring and drain hose from inside of the wall and hang outside of the hole. A minimum of 12″ of electrical wiring and 20″ of drain hose is recommended.
- Step 3. Mount Bezel to Wall
- Pull electrical wiring and drain hose through the bezel opening.
- Place bezel flanges inside of the hole in the wall so that the bezel back surface rests flat against the wall. Make sure bezel is level.
- Locate the four holes on the bezel and fasten to the wall with the appropriate screws based on the stud type. Screw A can be used for wood studs and Screw B for metal studs. Using a bit extension is recommended.
- Step 4. Prepare In-Wall Dehumidifier for Bezel Installation
- Punch the appropriate knock out holes for the drain hose and electrical wiring on the dehumidifier.
- Punch the appropriate knock out holes for the drain hose and electrical wiring on the dehumidifier.
- Step 5. Install In-Wall Dehumidifier to Bezel Lift and support the dehumidifier by the plastic drain pan below the evaporator coil. Two people may be required to hold and fasten the unit in place. Locate the four slotted holes on the dehumidifier. Use Screw A to fasten the unit to the bezel through the slotted holes. Connect the electrical wiring and route and connect the drain hose to the drain pan.
- Step 6. Install Diffuser Cover Place the hooks of the front diffuser cover into the slots at the base of the dehumidifier before fastening.
- Locate the four holes on the diffuser cover and fasten to the dehumidifier using either Screw C (Tamper Resistant) or Screw D (Phillips Head) included with the unit. Using the tamper resistant screws requires the ¼” Hex T-15 Torx Security Bit included with the unit.
- Locate the four holes on the diffuser cover and fasten to the dehumidifier using either Screw C (Tamper Resistant) or Screw D (Phillips Head) included with the unit. Using the tamper resistant screws requires the ¼” Hex T-15 Torx Security Bit included with the unit.
TOLL-FREE 1-800-558-1711
www.Broan-Nutone.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>