joie Traver Group 2/3 Toddler Car Seat Instruction Manual

Traver Group 2/3 Toddler Car Seat
Instruction Manual

ECE R44.04
Group 2/3(15-36kg)

Traver Group 2/3 Toddler Car Seat

Welcome to Joie™
Congratulations on becoming part of the Joie family! We are so excited to be part of your journey with your little one. While traveling with Joie traver™ series high back booster you are using a high quality, fully certified safety Group 2/3 booster. This product is suitable for use with children weighing 15-36kg (approximately 3-12 years). Please carefully read this manual and follow each step to ensure a comfortable ride and best protection for your child.

Please confirm
This booster is approved to UN Regulation No. 44, 04 series of amendments. This booster can be installed using a 3 point retractable adult seat belt approved to UN/ECE
Regulation No. 16 or other equivalent standards.

Booster
! IMPORTANT: KEEP FOR FUTURE REFERENCE. PLEASE READ CAREFULLY.
Please keep the instruction manual in the storage compartment at the bottom of the booster as right figure. For warranty information, please visit our website at joiebaby.com

Parts List

Make sure all parts are available before assembly. If any part is missing, please contact local retailer. No tools are required for assembly.

1 Head Support
2 Lower Back Support
3 Armrest
4 Seat Depth Adjustment button
5 Base| 6 Head Support Adjustment Lever
7 Shoulder Belt Guide
8 Isosafe Connector
9 ISOFIX Guides
---|---

WARNING

! Do take care to locate and install the booster so that it is not liable to become trapped by a moveable seat or in a door of the vehicle.
! This booster is designed ONLY for child weighing 15-36kg (approximately 3-12 years or under).
! Any straps of vehicle seat should be tightened and not twisted.
! Failure to properly use this booster increases the risk of serious injury or death in a sharp turn, sudden stop or crash.
! DO NOT use another manufacturers soft goods with this booster. See your retailer for Joie replacement parts only.
! DO NOT use in any configuration not shown in the instructions.
! NEVER leave your child unattended.
! NEVER give this booster to someone else without also giving them this manual.
! DO NOT modify your booster or use any accessories or parts supplied by other manufacturers.
! After your child is placed in this booster, the safety belt must be used correctly, and ensure that any lap strap is worn low down, so that the pelvis is firmly engaged.
! Replace the booster after an accident of any kind. An accident can cause damage to the booster that you cannot see.
! NEVER leave a booster unsecured in your vehicle. An unsecured booster can be thrown around and may injure occupants in a sharp turn, sudden stop or crash. Remove it or make sure that it is securely belted in the vehicle.
! NEVER leave luggage or other objects unsecured in a vehicle, they are liable to cause injuries in the event of a collision.
! NEVER use a booster if it has damaged or missing parts. DO NOT use a cut, frayed or damaged vehicle seat belt.
! The booster can become very hot if left in the sun. Contact with these parts can burn your child’s skin. Always touch the surface of any metal or plastic parts before putting your child in the booster.
! NEVER use a second-hand booster or a booster whose history you do not know.
! DO NOT use this booster without the soft goods.
! The soft goods should not be replaced with any besides the ones recommended by the manufacturer, because the soft goods constitute an integral part of the booster performance.
! DO NOT use any load bearing contact points other than those described in the instructions and marked on the booster.
! DO NOT face your booster toward the rear of the vehicle.
! Please do not use this child restraint if the child restraint has dropped from a significant height, hit the ground at a considerable speed, or has visible signs of damage. We are not responsible to replace if the child restraint has been damaged under these abnormal conditions. A new child restraint will need to be purchased when any of the aforementioned conditions occurs.

Emergency
In case of emergency or accidents, it is most important to have your child taken care of with first aid and medical treatment immediately.

Product Information

Read all the instructions in this manual before using this product. This booster can be installed in a semi-universal way by using the Isosafe system and a 3-point retractable adult seat belt approved to UN/ECE Regulation No. 16 or equivalent standards or in a universal way by using the before mentioned 3-point belt only. If in doubt, consult  either the booster manufacturer or the retailer.

For Installation with 3-point-belt

1. This booster is a ‘Universal’ child restraint. It is approved to UN Regulation No. 44, 04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a ‘Universal’ child restraint for this age group.
3. This booster has been classified as ‘Universal’ under more stringent conditions than those which applied to earlier designs which do not carry this notice.

For Installation with Isosafe System and 3-point-belt

1. This booster is a ‘Semi-Universal’ child restraint. It is approved to UN Regulation No. 44, 04 series of amendments for general use in vehicles fitted with ISOFIX  anchorages systems.
2. It will fit vehicles with positions approved as ISOFIX positions (as detailed in the vehicle handbook), depending on the category of the booster and of the fixture.
3. If in doubt, consult either the booster manufacturer or vehicle manufacturer.

Booster Assembly

see images 1- 5

1. Squeeze the head support adjustment latch first and then slide in lower back support under the fabric cover to connect them together. 1
   ! CHECK to make sure two pieces are securely snapped together by pulling on them.

2. To attach the backrest to the base, hook the lower back support over the seat bar hinge on the base. 2
   

3. Rotate the backrest up while holding the booster seat until it clicks into an upright position. 3

4. Align the side impact shield with the slot of lower back support plastics mounts, and then insert to lock. 4 5

Adjust the seat

see images 6 Height Adjustment – for Head Support
see images 7

Concerns on Installation

see images 8 – 11

Installation using Isosafe System and 3-point belt or using 3-point belt only
(Forward Facing Mode/ for Child between 15-36kg / 3–12 years old)
see images 12 – 24
If vehicle is equipped with ISOFIX, the vehicle lower anchor points may be visible at the vehicle seat crease. See your vehicle owner’s manual for exact locations, anchor identification, and requirements for use.

1. Fit the ISOFIX guides with the ISOFIX anchor points. 12 The ISOFIX guides can protect the surface of the vehicle seat from being torn. They can also guide the Isosafe connectors.

2. Press the Isosafe adjusting button to pull out the Isosafe connectors. 13Rotate the Isosafe connectors 180 degrees until they are pointing in the direction of the ISOFIX guides. 14

3. Line up the Isosafe connectors with the ISOFIX anchor points, and then click both Isosafe connectors into the ISOFIX anchor points. 15
   ! Make sure that both Isosafe connectors are securely attached to their ISOFIX anchor points. The colors of the indicators on the both Isosafe connectors should be completely green. 15 -1
   ! Check to make sure the booster is securely installed by pulling on the both Isosafe connectors.

4. To remove the booster: a. Press the secondary lock button 16 -1 first and then the button 16 -2 on the Isosafe connectors before removing the booster from the vehicle seat. b. Rotate the Isosafe connectors by 180 degrees, then press the Isosafe adjusting button to fold the Isosafe connectors. 17! Pull the vehicle safety belt and pass through the belt path 20 , and then buckle it up. 20 -3

! Could also be installed by using 3-point belt only. (see images 20- 24)
! Position shoulder belt through the shoulder belt guide shown in 20 -1
! DO NOT position vehicle belt over top of the armrests. It must pass underneath the armrests. 20 -2
! The booster can not be used if the vehicle safety belt buckle (female buckle end) is too long to anchor the booster securely. 20 -4

! After your child is placed in this booster, the safety belt must be used correctly, and ensure that any lap strap is worn low down, so that the pelvis is firmly engaged. 20
! To ensure the correct head support height is obtained, the bottom of the headrest MUST be even with the top of child’s shoulders as shown in 21 and the shoulder belt must be positioned in the red zone as shown in 22
! Place a booster firmly against the back of a forward-facing vehicle seat equipped with a lap/shoulder belt.
! Have your child sit in a booster with their back flat against back of a booster.

Detach Soft Goods

see images 25- 28
! After removing the wedge of insert, please store it somewhere that the child can not access it.28
To refit the seat pad simply reverse the steps above.

Care and Maintenance

! Please wash the soft goods and inner padding with cold water under 30°C.
! Do not iron the soft goods.
! Do not bleach or dry clean the soft goods.
! Do not use undiluted neutral detergent, gasoline or other organic solvent to wash the booster. It may cause damage to the booster.
! Do not twist the soft goods and inner padding to dry with great force. It may leave the soft goods and inner padding with wrinkles.
! Please hang dry the soft goods and inner padding in the shade.
! Please remove the booster from the vehicle seat if not in use for a long period of time. Put the booster in a cool, dry place and somewhere your child cannot access it.

Allison GmbH
Adam-Opel-Straße 21 67227
Frankenthal
bring the kids™
P-IM0089U_1
Share the joy at joiebaby.com

References

• Baby Gear That Goes Above & Beyond | Joie

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>