BLACKFIRE BBM9112 Rechargeable Portable Fan

CONTENTS

• BBM9112 Rechargeable Portable Fan
• 42″ (106.7 cm) USB-C Cable
• Instruction Manual

GENERAL SPECIFICATIONS

• Cell Type: 18650 Lithium-ion
• Capacity: 5200mAh (18.7Wh)
• Operating/Storage Altitude: 6562 ft. (2000 m)
• OperatingTemperature: 14° to 104°F (-10° to 40°C)
• Charging Temperature: 32° to 104°F (0° to 40°C)
  • (For optimum charging, ambient temperature should be below 86°F (30°C))
• Storage Temperature: -4° to 113°F (-20° to 45°C) (up to 3 months)
• Storage Humidity: <75% Relative humidity
• Operating/Charging Humidity: <85% non-condensing
• Runtime (minimum): High 5 hour, Low 9 hours
• Charging Time: Full charge in 4.5 hours under optimum charging conditions
• Shelf Life: Fully charge every 3 months
• Life Expectancy: Up to 500 cycles typical (depending on use & care)
• Charging Requirements: 5V 2.0A, 10W
• Dimensions: 10.6″ x 9″ x 4″ (269 x 228 x 101 mm)
• Weight: 2.37 lb (1076 g)
• Drop Protection: 3 ft. (.91 m)
• Ingress Protection Rating: IP54
• Standards: UL 507, CSA C22.2 No. 113-18, FCC: 47CFR Part 15(2018) and ANSI C63.4 (2014), UL 2054, IEC 62133, UN38.3, DOE/CEC, IEC #60335-1, #60335-2-80, RoHS, REACH, NRCan, NOM-003-SCFI-2000 / NMX-J-521/1-ANCE-2012

Specifications subject to change.

PRECAUTIONS

• Read, understand, and follow these instructions to ensure safe operation. Failure to observe these warnings can result in risk of fire, electric shock, serious injury and/or property damage.
• Use of a power supply, charger, or cable not recommended or sold with this unit may result in a risk of fire or injury to persons.
• DO NOT use the product that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
• DO NOT subject to vibration, impacts, or drops. The housing may not show signs of damage, but internal components may have been compromised. It is advisable to replace the unit if any such severe events occur.
• DO NOT expose to direct sunlight, open flame, heat sources, equipment that produces heat, or extremes in environmental temperature.
• DO NOT expose product to rain or snow.
• Keep away from high voltage devices.
• DO NOT attempt to repair the fan or charging cable. There are no user-serviceable parts.
• DO NOT immerse in water or other liquids. Avoid spilling liquids or falling foreign objects into openings on the enclosure.
• Risk of fire and burns. DO NOT open, crush, heat above manufacturer’s specified maximum temperature or incinerate.
• Water-resistant port cover must be properly sealed to achieve specified water & foreign object ingress protection. Keep seal free of dirt, oil, sand, or other material that interferes with proper sealing.
• Failure to do so can result in risk of fire or electric shock.
• DO NOT open water-resistant cover if wet or in a wet environment. Thoroughly dry the unit and the seal around water-resistant cover completely before opening water-resistant cover.
• When the fan is in use or charging, make sure there is adequate space to allow ventilation of internally generated heat.
• Use safety-rated power supply or wall adapter. Never use power supply or wall adapter that exceeds the specified charging voltage and current.
• Route the power supply cable so that it will not to be stepped on or pinched by other objects.
• DO NOT attempt to insert other USB connector types into USB-C port.

MAINTENANCE

CLEANING

• Be sure device disconnected from all power sources and devices. Use clean, dry, soft, lint-free cloth to wipe down the entire unit. Do not use abrasive cleaners or solvents.

STORAGE

If storing for more than 1 month, charge completely before storage, and recharge approximately every 3 months to avoid full discharge. Store in cool temperatures, mild humidity, and away from direct sunlight (See GENERAL SPECIFICATIONS). Leaving in a vehicle or other confined spaces in extreme hot temperatures can lead to decrease in service life, overheating, or fire. Extreme cold temperatures below the specified storage range can also harm performance and service life. Keep away from corrosive chemicals and gases. After taking out of storage, inspect visually to make sure device and all accessories look satisfactory. Allow unit to return to ambient conditions before recharging or charging other devices.

RECHARGING: Recharge as needed. There are no pre-designated intervals at which to recharge as long as you are using the unit regularly. Avoid discharging completely on a regular basis, as this can impact overall life. Regularly inspect ports and charging cable for any debris, dirt, damage, and corrosion. DO NOT attempt to fix. Replace device and/or cable as needed.

FEATURE DETAILS

1. Fan blades
2. Fan cage
3. Fan cage arms
4. Clamp
   • (with rubberized grip)
5. Handle
6. Power button
7. Battery status indicator
8. Charging port flap
9. USB-C input

10. 10D Nail Hole

11. Hooks (x2)

WARRANTY

• www.blackfire.com/warranty

DISPOSAL / RECYCLE

• Do not place equipment and its accessories in the trash. Items must be properly disposed of in accordance with local regulations.
• Please see www.epa.gov/recycle for additional information.

SYMBOLS ON PRODUCT

• Warning or Caution
• Risk of Electrical Shock
• Read Instructions
• Conforms with European Economic Area directives
• Conforms with United Kingdom Conformity Assessment Requirements
• WEEE: Electronics disposal
• IP54 Ingress Protection Rating
• Independently tested by Intertek and meets applicable standards
• Energy efficiency verified

OPERATING INSTRUCTIONS

Read these instructions carefully before operating and keep for future reference.

CHARGING BATTERY

• Connect USB-C cable connection to the fan, plug the other end of cable into USB (2.0 or higher) port, or AC adapter (not included). USB adapter/power supply should not exceed the specified charging voltage and current (Max. 5.0V DC, min. 2.0A).
• The battery level indicator bars will illuminate (see TABLE 1 below):
  • 4 bars solid (Red, Yellow, 2 Green solid): 100% charge
  • Red solid, yellow solid, one green solid: 75% to 99% charge
  • Red solid, yellow solid, one green blinking: 50% to 74% charge
  • Red solid, yellow blinking: 25% to 49% charge
  • Red blinking: 0% to 24% charge
• A full charge could take up to 4.5 hours, depending on the charger’s output. Charge completely before using. To maximize battery life, see the MAINTENANCE section (other side).
• To check the battery level, press and hold the power button for 5 seconds. The battery level will illuminate without changing the speed of the fan.

TABLE 1

USING THE FAN

Pressing the power button will show battery level, releasing the button will turn on the fan:

• Press and release once to turn the fan on HIGH
• Press and release a second time to turn the fan on LOW
• Press and release a third time to turn the fan OFF

NOTE: When charging the fan, the unit will operate at LOW speed only.

MOUNTING OPTIONS

• Clamp – open the clamp by squeezing the handles together. Open the clamp fully and push as far onto the intended object before releasing the clamp. The rubberized texture inside the clamp provides better grip to materials including conduit.
• Hooks – two integrated hooks can be used to hang from interior tent loops and small tree branches.
• Nail hole – place the hole over the nail head and slide into the slot for secure mounting.

TROUBLESHOOTING

BBM9112 will NOT recharge IF

• The cable is not properly connected to charger output or battery input. Check connection.
• The charging cable is damaged. Replace with equivalent cable.
• The charging port or device is not able to supply the minimum voltage and current for charging. Connect to appropriate charging source.
• The connector on the charger is damaged. Replace charger.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.

IC NOTICE TO CANADIAN USERS

This device complies with industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation of the device.

This device complies with RSS-247 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference. This Class B digital apparatus complies with Canadian ICES-003.

CUSTOMER SERVICE

BLACKFIRE, INC.

• 661 E Main St Unit 200-117, Midlothian, Texas 76065
• 1-877-572-4184
• customerservice@blackfire.com
• www.blackfire.com

References

• Blackfire | Solar-Ready Portable Power Stations, Rechargeable Accessories, and Tools
• Warranty | Blackfire.com
• Reduce, Reuse, Recycle | US EPA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>