LEE BF5158 App Tube Retainer and Cap Instructions
- June 9, 2024
- LEE
Table of Contents
LEE BF5158 App Tube Retainer and Cap
Product Information
The BF5158 is a bullet feeding system by Lee Precision, Inc. It comes with various components including cylinder, mag spacer, feed plate hex plug, round retainer nut, set screw, mag spacer, washer, mag spacer, bullet feed cap, and multi-tube adapter. The clear tubes encapsulate the bullet feed magazine cylinders, and the set screw is needed to retain the bullet feed magazine cylinder to the bullet feed plate. The round retainer nut is used to retain the feed tubes to the spline drive adapter.
Product Usage Instructions
- Remove the 6-32 x 5/8 round head screw that retains the bullet feed magazine cylinder to the bullet feed plate. Set aside the set screw as it will be needed later.
- Verify that the set screw is installed into one end of the mag spacer.
- Install the mag spacer with setscrew end into the bullet feed plate. Lightly finger tighten the mag spacer into the plate. Rotate the cylinder as you tighten. If the mag spacer is tightened too far, the cylinder will not freely rotate.
- Install appropriate sized clear tubes into bullet feed magazine cylinder.
- Install bullet feed magazine cylinders onto the end of clear tubes so that each end of tubes are encapsulated.
- Use the 6-32 x 5/8 round head screw from step one, in addition to the washer to thread into opposing end of mag spacer.
- Install round retainer nut on hex plug. This retains the feed tubes to the Spline Drive Adapter.
Note: The Cylinder # BF5383 can be attached using Cylinders 6-32 x 3/8 Round HD # BF5383 # FP2283
PRODUCT OVERVIEW
INSTALLATION INSTRUCTION
- Remove 6-32 x 5/8” round head screw that retains bullet feed magazine cylinder to Bullet Feed Plate. Set screw aside, will need for step 6.
-
Verify set screw is installed into one end of spacer.
-
Install mag spacer with setscrew end into bullet feed plate. Lightly finger tighten mag spacer into plate. Rotate cylinder as you tighten. If mag spacer is tightened too far, cylinder will not freely rotate.
-
Install appropriate sized clear tubes into bullet feed magazine cylinder.
-
Install bullet feed magazine cylinders onto end of clear tubes, so each end of tubes are encapsulated.
-
Use 6-32 x 5/8 round head screw from step one, in addition to the washer to thread into opposing end of mag spacer.
-
Round retainer nut can now be installed on hex plug. This retains the feed tubes to the Spline Drive Adapter.
ABOUT COMPANY
- LEE PRECISION, INC.
- 4275 County Road U
- HARTFORD WISCONSIN 53027
- www.leeprecision.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>