LEE BF2698 Inline Bullet Feed Die Instruction Manual
- June 9, 2024
- LEE
Table of Contents
LEE BF2698 Inline Bullet Feed Die
Product Information
The Inline Bullet Feed (40 Cal.) is a product designed for efficient bullet
feeding during reloading. It comes with a Pistol Bullet Feed Body, Bullet Feed
Sleeve, Bullet Feed Cap BF5385, Sleeve Return Spring BF5377, and 1/8 Detent
Balls (qty. 2). This product is suitable for 40S&W and 10MM calibers.
Optional Accessories
For added convenience, consider ordering the gatling-style magazine feed (#92016) or the single tube adapter (#92024) if loading lower quantities.
Setup Instructions
To set up the Inline Bullet Feed, follow these steps:
- Measure the cylindrical portion of the projectile known as the ‘A’ section.
- Select the correct hole for your bullet from the Bullet Length Chart. Ensure that you do not include the bullet’s boat tail or ogive profile while measuring.
- Insert the Pistol Bullet Feed Body into the press and screw it in until it is secure.
- Place the Bullet Feed Sleeve onto the Pistol Bullet Feed Body.
- Insert the Detent Balls into their respective slots on the Pistol Bullet Feed Body and ensure they are securely in place.
- Attach the Bullet Feed Cap BF5385 onto the top of the Bullet Feed Sleeve.
- Attach the Sleeve Return Spring BF5377 to the Pistol Bullet Feed Body and to the Bullet Feed Cap BF5385.
- Thread die into the press a couple of turns.
- Place a flared case into shell plate.
- Fill the bullet feed sleeve with bullets, base down, with one protruding.
- Raise case to top of stroke. Screw die clockwise until the bullet stack drops plus an additional ½ turn.
- Finger tighten lock ring, tighten split clamp with 3/32” hex key.
Tips for Success
Follow these tips to ensure successful use of the product:
- Change ball position over a tray or container to prevent losing balls. (Replacements #92063).
- Keep the bullet stack near the top of the sleeve; the weight of bullets aids in seating a bullet into the case.
- Adequate case mouth flare is required to reduce bullet tipping.
Bullet Length Chart
*Provides a starting point, bullet profile will factor into correct hole selection.
- For the ultimate in convenience, order the gatling style magazine feed.
- If loading lower quantities, consider the single tube adapter.
Troubleshooting
If you encounter any issues with the product, refer to this table for solutions:
| Symptom | Solution |
|---|---|
| No bullets feed, but sleeve returns to home position. | The die must be screwed |
into the press further.
Multiple bullets feed, or one feeds while the sleeve does not fully return to
home position.| The bullet is too short for the selected hole; move balls to
the lower hole.
No bullets feed, and sleeve does not fully return to home position.| The
bullet is too long for the hole being utilized; move balls to a higher hole.
Product Warnings
This product may contain steel alloyed with trace amounts of lead and other
elements that are known to cause reproductive harm and cancer in the State of
California. For more information, go to www.P65Warnings.ca.gov. To prevent
exposure, do not alter the product by welding, grinding, etc.
WARNING: This product may contain steel alloyed with trace amounts of
lead and other elements which are known to the State of California to cause
reproductive harm and cancer. For more information, go to
www.P65Warnings.ca.gov. To prevent exposure, do not alter the product by
welding, grinding, etc.
For more information about this product, visit www.leeprecision.com.
LEE PRECISION, INC.
4275 COUNTY ROAD U · HARTFORD WI 53027
www.leeprecision.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>