lee stafford 138570217 Curl Up & Dry Air Styler User Guide
- June 5, 2024
- lee stafford
Table of Contents
lee Stafford 138570217 Curl Up & Dry Air
Styler
This unit comes with a removable UK 3-pin plug. The 3-pin plug can be removed to reveal a European 2-pin plug by unscrewing the centre screw, lifting the rear cover and unclipping the European 2-pin plug. It can be replaced if necessary by reversing this procedure.
WIRING INSTRUCTIONS UK PLUGS ONLY
This product is fitted with a BS1363 or BS5733 plug fused at 5A. If the plug is unsuitable, it should be disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace the plug fuse, use only fuses that are approved to BS1362, rated at 5A. If in doubt consult a qualified electrician. The wires in the mains lead are coloured in accordance with following code:
BLUE – NEUTRAL BROWN – LIVE
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:- The wire which is coloured BLUE must be connected to the
terminal which is marked ‘N’ or coloured BLACK.The wire which is coloured
BROWN must be connected to the terminal which is marked ‘L’ or coloured RED.
Never connect either of the wires to the big EARTH terminal marked ‘E’ or
coloured GREEN or GREEN AND YELLOW.
24-month warranty
This product has been checked and is free of defects. We warrant this product against any defects that are due to faulty material or workmanship for the warranty period from the original date of consumer purchase. If the product should become defective within the warranty period, we will repair any such defect or elect to replace the product or any part of it without charge provided there is proof of purchase. This does not mean an extension of the warranty period. Simply mail the appliance to your nearest Service Centre, with proof of purchase.This warranty is offered over and above your normal statutory rights.The warranty shall apply in all countries in which our product was sold via an authorised dealer.This warranty does not include damage to the product by accident or misuse, abuse, alteration to the product or use inconsistent with the technical and/or safety instructions required. This warranty shall not apply if the product has been dismantled or repaired by a person not authorised by us.
Features
KEY FEATURES:
- 1200W Airstyler
- 2 heat/speed settings including cool air
- 3m Swivel cord
- Brush lock/release button
- 38mm Big Brush attachment for a quick, easy, big & bouncy blow-out.
- 32mm – 15cm Air Wand attachment for bouncy, weightless curls.
TO FIT OR REMOVE ATTACHMENTS
Ensure the airstyler is turned off and the attachment is cool before
removing.To remove, press and hold the brush lock / release button and twist
the attachment clockwise about 5mm until the attachment detaches from the
airstyler handle.To attach, align the “-“ symbol on the handle with the lock
symbol on the attachment and twist it about 5mm anti-clockwise until the
symbols are aligned and the brush lock / release button clicks into place.
USE:
The Air Styler can be used on dry hair but it best on clean, slightly damp hair.Use as you would a normal hairbrush, brushing or curling for a few seconds at a time. To freeze the style into place, apply the cool setting before unrolling the brush from the hair. Use styling sprays in use or a setting spray to fix the final style.
CLEANING AND MAINTENANCE :
Make sure the unit is cool, switched off and unplugged.Housing may be wiped with dry, lint-free cloth. Special attention must be taken to removed hair and dust from the air intake. Attachments can be cleaned with a damp cloth and should be allowed to dry overnight before using again.
IMPORTANT INSTRUCTIONS
SAFETY CAUTION S
WARNING
FOR ADDITIONAL PROTECTION THE INSTALLATION OF A RESIDUAL CURRENT DEVICE (RCD)
WITH A RATED RESIDUAL OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK
AN ELECTRICIAN FOR ADVICE.
WARNING
THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM, IT SHOULD NOT BE USED
NEAR BATHTUBS, SHOWERS, BASINS OR OTHER VESSELS CONTAINING WATER OR OTHER
LIQUIDS.
This product is not suitable for use in bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT IN USE.
-
Do not leave the styler unattended when switched on.
-
Allow the styler to cool down before storage.
-
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc. -
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
-
Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can give cause to hazards.
-
Persons responsible for their safety should give explicit instructions or supervise the use of the appliance.
-
Do not use any attachments with this styler, other than those supplied by Diva Professional Styling.
-
Avoid allowing any part of the hot plates to contact the face, neck or scalp.
-
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
-
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorised service dealer for repair or replacement in order to avoid a hazard. Special tools are required for any examination, adjustment or repair. Unqualified repair work could lead to hazardous conditions for the user.
-
We do not accept responsibility for damage to the product, persons or other items(s), caused by misuse, abuse or non-compliance with these instructions.