LEE BF5092 Inline Bullet Feed Die User Manual
- June 9, 2024
- LEE
Table of Contents
**LEE BF5092 Inline Bullet Feed Die
**
Product Description
SETUP INSTRUCTIONS
- Measure projectile’s cylindrical portion, “A” section.
Refer to the bullet length chart (see reverse) to confirm the two detent balls are installed in correct holes of bullet feed sleeve. Detent balls are installed in upper holes from factory.
- Thread die into the press a couple of turns.
- Place a flared case into shell plate.
- Fill the bullet feed sleeve with bullets, base down, with one protruding.
- Raise case to top of stroke. Screw die clockwise until the bullet stack drops plus an additional ½ turn.
- Finger tighten lock ring, tighten split clamp with 3/32” hex key
TIPS FOR SUCCESS
- Change ball position over a tray or container to prevent losing balls. (Replacements #92061)
- Keep bullet stack near the top of the sleeve, weight of bullets aids in seating a bullet into the case.
- Adequate case mouth flare is required to reduce bullet tipping.
Bullet Length Chart
*Provides a starting point, bullet profile will factor into correct hole selection.
Maximum Cylindrical Length
*Do not include boat tail or ogive profile.
-
A= .350” or shorter
-
A= .350” to .750”
-
For the ultimate in convenience, order the gatling style magazine feed.
92014
-
If loading lower quantities, consider the single tube adapter.
92024
-
Replacement balls
92061
Troubleshooting
| Symptom | Solution |
|---|---|
| No bullets feed, but sleeve returns to home position. | Die must be screwed |
into press further.
Multiple bullets feed, or one feeds but sleeve does not fully return to home
position.| Bullet is too short for hole selected, move balls to lower hole.
No bullets feed and sleeve does not fully return to home position.| Bullet is
too long for the hole being utilized, move balls to higher hole.
WARNING: This product may contain steel alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. For more information, go to www.P65Warnings.ca.gov. To prevent exposure, do not alter the product by welding, grinding, etc.
Customer Service
LEE PRECISION, INC.
4275 COUNTY ROAD U · HARTFORD WI 53027
www.leeprecision.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>