OKIN RF411A-11 Remote Control User Manual
- June 9, 2024
- OKIN
Table of Contents
A Phoenix Mecano Company
RF411A-11 Remote Control
User Manual
RF411A-11
Item
1.1 Left + button 1
Click the left + button, in flat the left airbag.
1.2 Left – button 2
Click the left – button, leak the left airbag.
1.3 Right + button 3
Click the right + button, in flat the left airbag.
1.4 Right – button 4
Click the right – button, leak the left airbag.
1.5 STOP button 5
Click the STOP button, Sopt the operation.
1.6 Left heat 6
Click the left heat button, heat the left side of the bed.
1.7 Child lock 7
Click Child lock button, lock and unlock the remote.
1.8 Right heat 8
Click the right heat button, heat the right side of the right.
1.9 Head message
Click MASSAGE HEAD button, head massage motor switches massage intensity,
massage intensity switches among 0-1-2-3 ；
1.10 Message time
Click the massage time button to change the massage time 10-20-30 mins.
1.11 Foot massage
Click MASSAGE Foot button, head massage motor switches massage intensity,
massage intensity switches among 0-1-2-3 ；
1.12 Child Lock
Press the child lock key for 5 seconds to lock the remote.
1.13 Sync key
Press the Sync key key to connect the control box.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF warning for Portable device
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED RSS Warning/ISED RF Exposure Statement
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
ISED RF exposure statement
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
A Phoenix Mecano Company
Issue Department: Bedding Division
Date: 2022-10-10
Edition: 1.1