CERBERUS PYROTRONICS Lever Actuated Control Head Owner’s Manual
- June 9, 2024
- CERBERUS PYROTRONICS
Table of Contents
Lever Actuated Control Head
Owner’s Manual
ENGINEER AND ARCHITECT SPECIFICATIONS
Model LAH Features:
- Used for Manual Actuation of Cylinder
- Comes Equipped with Safety Pull-Pin, to Prevent accidental Manual Discharge of FM-200TM Cylinder
- Self-Venting
- Solid Brass Construction
- Stainless Steel Lever
- Listed and FM Approved
Introduction
Model LAH, the Lever Actuated Head is equipped with an operating lever, for
manual actuation of Ceberus Pyrotronics FM-200™ cylinders. The LAH is secured
in a closed position by a safety pull-pin. When the safety pull-pin is
removed, the lever can be manually rotated to the open position. When the
lever is in the open position, it allows for the activating of the cylinder
or valve on which it is installed.
The lever operated control head is self-venting to prevent accidental system
discharge in the event of a slow buildup of pressure in a pilot line.
Ensure that the control head is in the “SET” position, with the safety pull-
pin and seal wire intact. Next, remove the protection cap from the cylinder or
stop valve actuation port. Using a suitable wrench, assemble the control head
to the cylinder valve. Finally, tighten the swivel nut securely.
Ordering Information
| Model No | Description | Part No. |
|---|---|---|
| LAH | Lever Actuated Control Head | 500-870652 |
Mounting Data
Cerberus Pyrotronics
8 Ridgedale Avenue
Cedar Knolls, NJ 07927
Tel:201-267-1300
FAX:201-397-7008
11/96 1M CPY-IG
Printed in U.S.A.
Cerberus Pyrotronics
50 East Pearce Street
Richmond Hill, Ontario
L4B, 1B7 CN
Tel:905-764-8384
FAX:905-731-9182
November 1996
Supersedes sheet dated 10/95
firealarmresources.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>