LEHNER VERSAND 5450569 Electric Grill Instruction Manual

LEHNER VERSAND 5450569 Electric Grill Instruction Manual

Before use

Please read these instructions carefully. They will give you important advice for the use, security and maintenance of this appliance. Keep these instructions and, should the situation arise, pass them on to other users. The appliance must only be used for the intended purpose according to these instructions.

F Safety regulations

• This appliance is not meant for commercial use but exclusively for private

• This appliance can be used by children aged from 8 years and above, so as persons with reduced physical, sensory or mental capabilities, but only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards Children must not play with the appliance.
  Cleaning and user maintenance shall not be done by children without constant supervision. Keep the appliance and its cord out of reach of children less than 8 years.

• Plug the appliance only in an outlet as mentioned on the rating plate and only plug it into an earthed, three-pin

• Use only one appliance per socket and use only earthed extension cables in safe condition, with earth wire cross section of at least 0mm2 (capacity at least 10A).

• It is strongly recommended that power for any domestic appliance must only be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA. Consult your electrician for

• Only the appropriate power cord as supplied with this unit must be

• Power cord and appliance should be regularly examined for signs of damage.
  Stop using immediately by disconnecting the power cord if any damages have been noted.

• The appliance must not be operated (disconnect the mains plug immediately) when:

  • the appliance, casing or power cord is
  • the appliance shows visible signs of
  • other problems with the appliance have been registered
  • a fault is suspected after the appliance has been dropped or

• This appliance is not intended to be operated by means of an external timer or separate remote-control

• Switch off at the power point and disconnect the main plug:

  • in case of faults during
  • before cleaning or moving the appliance from place to
  • after use

• If the power cord is damaged, it must be replaced only by the manufacturer, their after-sales service department or a similarly qualified person in order to avoid

• Do not use this appliance within reach of water contained in bath-tubs, washbasins or other Never expose it to rain, snow or other moisture.

• Never place your appliance on an unstable, wet, fragile or angled Only place on heat resistant surfaces.

• Position the power cord and cable so that unintentional touching or catching is impossible.

• Never allow the extension lead or power cord to be in touch with the hot grill

• Don’t pull the power cord over sharp Don’t wedge (eg under doors etc.).

• Do not stand the BBQ over the edge or corner of a table and avoid all contact with the BBQ hot

• Do not place the appliance on or near a hot gas electrical burner, or in a heated

• Do not use the appliance without the grease cup and the BBQ base all fitted properly

• Never cover the hotplate with aluminum foil or trays (this might damage the non-stick coating).

• Make sure without fail that this appliance is assembled correctly before

• Keep the electric grill at least 30 cm from any walls when in

• The temperature of accessible surfaces may be dangerously high when the appliance is Take care when the appliance is in use. Keep it away from combustible materials.

• Take care! The hotplate will get very hot, and it stays hot for a long time after it has been switched off. Beware of burns! Do not touch any hot surfaces and take care when handling the appliance after

• The temperature of the surface will be very high when using, please keep it away from

• Beware of fat oil or moisture spitting while

• Do not leave the appliance unattended when switched on or still

• Do not touch the appliance (cover or grill plate) when cooking in order to prevent any risk of burning.

• Charcoal or similar combustible fuels must not be used with this

• Use this appliance only as described in this Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons possibly resulting in depth or permanent disablement.

• This appliance is only to be used for

• Never pull the plug out of the socket by the power cord or with wet

• Never carry nor pull the appliance by the power

• For safety reasons, do not use attachments that were not recommended or supplied by the

• Always switch off the appliance before removing the mains

• Before removing attachments or cleaning the appliance, allow it to cool

• The power cord must be removed before the appliance is cleaned and the appliance inlet must be thoroughly dried before the appliance is used again. Never immerse the power cord or the thermostat plug in water or any other

• No warranty for any possible damage can be accepted if the appliance is used for improper purpose, wrongly operated or unprofessionally In such a case, any warranty claim is void.

Electric diagram

Component

 Installation instructions

1. Take the trolley frame and accessories out from the packing box. Please make sure that the trolley frame is placed on a dry, flat and stable surface. Then let the wheel axle(a) pass through two holes which are at the end side of the tube. Set the frame supporter (Z1) to the curved pipe, fix the frame supporter and pipe with two M4*12 screws. Left and right side are the same setting method| **
---|---
2.** Attach the wheels (b) with the two sides of the axle

(a)   respectively.

|
3. There are two mounting holes on each end side of the axis(a), insert the “R” pin(c) through the hole. This will lock the wheel.| **
4. Press the wheel covers（d) to the wheels(b) according to the three location tips.| **
5. Stand up the trolley: First, step on the middle of supporting tube (I) with right foot , lift up the side table(II) with right hand whilst lift the tube for wheel

(III) upward with left hand. Then locate the tube (III) with the orientation tube which under the side table. The trolley frame is standing up now .

Fold down the trolley: First, step on the middle of supporting tube (I) with right foot, hold up the side table (II) with right hand whilst your left hand holds the short edge of support tube (III) and place it down slowly .

Attention : when folding down the trolley , DON’T hold the two sides of tube (III) to avoid any pinch to your hand.

|
6. After standing up the trolley frame, you MUST set the safety locking unit (f) immediately. This safety locking unit is with self-locking feature. Press the spring (e) and hook the bent hook(f) on the extension part (e). Then stop pressing the spring and it will retract to lock the safety hook unit automatically. Attention: Make sure the safety hook unit is LOCKED during cooking or moving. DO NOT try to turn or pull the safety hook while using this appliance.|
---|---
7. Firstly, remove the screw from the trolley tube (II). Then, install the stand tube (G1) onto the trolley tube (II). And install the stand tube (G2) onto the trolley tube (II). There is a positioning hole (IV) on the stand tube (G2), which is going to fix the bottom positioning projection of base. Tighten the stand tube (G1 and G2) and trolley with screws and nuts.|
8. Set the bowl-shaped base (h) into the stand tube (g) to the bottom. Fix the bottom positioning projection of base into the positioning hole (IV). When remove the base from stand tube (g), please step slightly on the supporting tube (I), hold the handles of base and take it off.| **
9. Install the cover. Holds the cover handle (p) and insert the metal hinges (O) into the installation holes (Q) of base. When remove the cover, please open the cover and tilt to 45° between cover and grill plate, and detach out the metal hinges (o) from installation holes (Q). Other angles can’t help to detach the cover but only around 45°.|
10.** Insert the detachable temperature regulator’s pin (n) into the heating tube socket (L). It can plug in the appliance. When remove the detachable temperature regulator, please hold the handle of the base to avoid pushing over the appliance.

Attention: Please take care. DON’T be tripped over by the power cord when operating the appliance. Remember to remove the plug after use.

| **
11.** The design of clamshell function and detachable cover makes it more convenient for using and cleaning.

Attention: If user wants to close or open the cover, please hold the cover handle. Mind yourself not be burnt as the metal cover is HOT while cooking.

|
---|---
12. Place the grill plate (K) on the base of the appliance (H). Firstly, insert the heating tube socket (L) of grill plate into the protective hole (M) intended for it slantways . Secondly, set the grill plate horizontally on the appliance base. To take grill plate off, please hold up the right side of the plate and take the pull socket (L) out of the protective hole(M) slantways. Before take the grill plate out , make sure it is cool and not in use.

Attention : The grill plate must be used together with bowl shaped base !

| **
13.** Insert the grease collecting cup (j) into the bracket supplied for it in the back of bowl-shaped base (h) of the appliance. In order to fix it well, please buckle the hole on grease collecting cup into the positioning projection which is in the middle of the bowl-shaped base. (Tips: This grease cup can be filled with little water to make it more easy to clean). To get the grease collecting cup out, please give it a slight press, after depart the hole from the positioning projection, you can take it out easily. The screw in butterfly shape (N3) is to set the main griller and frame together.

Attention: The capacity of grease cup is 0.3L, please pour out the grease once it’s full. The surface of grease cup is HOT. Please well protect yourself if needed to touch it while cooking!

| **
14.** Install the extra side table (R) according to the actual use.

Hold the side table (R) and press the two pins(S) with your thumbs. Then insert into tube (T). When folding up the trolley, please remove the side table

(R) first. Press the pins (S), then pull it out from tube (T) smoothly.

| **
15. When moving the folded trolley or when the appliance is not in use, please lock the buckle (V/W) with upper cover, and make sure the belt hook (U) lock the tube.| **

• Before using the appliance for the first time
• Remove all the packaging materials and wash the hotplate (3), grease cup (4) and roasting hood (1) thoroughly Important: Dry all the different parts thoroughly. This applies especially to the power inlet socket (15) . Never immerse the power cord with regulator (13) in water. Heat the grill to its maximum setting for about 3-5minutes, with the roasting hood in place and without any food. Residues left from manufacturing may cause some smell and smoke when the appliance is used for the first

F Cooking instructions

• Connect the appliance to the mains electricity
• Set the temperature regulator (13) to the required temperature level (it usually takes about 3 minutes to preheat). Pre heating is faster with the roasting hood in
• The temperature indicator lamp (14) will go out as soon as the required temperature has been
• Place the food to be grilled on the hotplate (3)

F Cooking times

The following are recommended cooking times. Different times will be required for different weights and sizes of foods to be grilled, and depending on whether you are grilling with or without the roasting hood. Weather conditions can also affect cooking times.

F Tips for grilling

• Your meat will be more flavorful if you marinade it in the refrigerator overnight before cooking (you can make your own marinade from oil (to aid moistness), vinegar, fruit juice or wine (to tenderize) and a mixture of seasonings for flavor).
• Always use tongs to turn grilled food (using a fork to turn the food will dry it out and damage the non-stick coating). Take care with tongs not to damage the non-stick
• Only turn meat and fish once during You do not need to turn it more than once and too much turning dries food out.
• Never cook meat for too Even pork is better if it is served when it is still a little pink and juicy.
• If cooked food sticks to the hotplate, rub the plate with a piece of kitchen paper soaked in oil from time to

F Cleaning and looking after the appliance

• Disconnect the appliance from the mains electricity
• Allow the grill to cool
• Take the power cord with regulator (13) out of the appliance
• Clean the hotplate (3) and grease cup bowl (4) with warm washing-up water and a damp
• Do not use steel wool pads, brush or abrasives to avoid any damages to the coating of
• Wipe the base of the appliance (5) with a damp Fat splashes can be removed with a mild cleaning agent.

Note:

• The hotplate has a non-stick coating.

Do not scratch this coating during either the cooking or the cleaning stages.

Tip:

• Protect the appliance from dust and dirt if it is not to be used for a prolonged length of time (dry thoroughly then wrap it in a plastic bag). Store it in a cool dry

F Disposal

Disable unserviceable appliances immediately. Remove the mains plug and cut up the mains connection cable. If possible, bring unserviceable appliances to an official waste collection point. Many local authorities provide removal services for bulky refuse at least once a year.
For service and warranty repairs please contact your place of purchase.

Specifications

• Power: 1400 – 1600W (190-220°C)
• Cable length: 3m
• Grill-Plate : 44x34cm
• Weight Net BBQ: 12kg

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>