AMEWI 22621 Hyper GO Brushed 4WD Instruction Manual

AMEWI 22621 Hyper GO Brushed 4WD

Welcome to AMEWI

The Amewi Trade GmbH is an international import- and wholesale company for R/C models, toys and creative items, located in Borchen near Paderborn, Germany. Our product range includes over 10,000 items. Above all, this includes remote- controlled car, helicopter, boat, and tank models as well as a wide range of accessories and all necessary spare parts. Our sales network includes over 700 specialist dealer and online retailers across Europe.
The company AMEWI Trade GmbH is a pure wholesale company. We only sell our products to retailers. When you purchase AMEWI products as an end consumer, you are entering into a contract with the retailer. Please always contact your dealer in warranty cases.

Service : Dienstag 9:30 – 12:00 Uhr
Donnerstag 14:00 – 16:30
Uhr Telefon: +49 180 5009821
(Festnetz 14Ct/Min., Mobil max. 42Ct/Min.)
Support: https://amewi.com

MAXIMUM TRANSMITTING POWER DATA

• Operation Frequency 2448 – 2475 MHz
• Maximum Radio Frequency power
  • Maximum peak power  -11,2dBm

DECLARATION OF CONFORMITY

This product has been manufactured according to actual technical standards. The product is matching the requirements of the existing European and national guidelines. The Declaration of Conformity has been proofed. AMEWI Trade GmbH declares that this product is matching the basic requirements and remaining regulations of the guideline 2014/53/EU {RED). The declarations and documents are stored at the manufacturer and can be requested and applied there. https://amewi.com/Konformitaetserklaerungen For additional questions to the product and conformity please contact: Amewi Trade GmbH Nikolaus-Otto-Str. 18, 33178 Borchen Germany or website https://amewi.com

SECURITY AND HAZARD WARNINGS

• For damage, caused by disregarding of the manual, warranty expires.
• We are not liable for secondary failures, material, or personal damage, caused by in proper usage or disregarding the security notices.
• Based on security and registration {CE) reasons, it is forbidden to modify the product personally. Do not disassemble the product.
• Small parts. Danger of suffocation or risk of injury caused by small parts.
• Suitable for people aged 14+!
• The product is not allowed to get moist or wet. The product is only allowed to be used on flat and clean surfaces. Even a drop down from a small height can cause damage to the product.

BATTERY NOTICE & DISPOSAL

• Attention! Battery do not belong in the hands of children. A change of the battery must be done by an adult person. Never mix rechargeable batteries with non-rechargeable batteries. Never mix fully charged batteries with almost empty batteries. Never mix batteries of different capacities. Never try to charge dry batteries. Take care of the correct polarity. Defective batteries belong to special waste. Never leave a charging battery unattended. For questions about the charging time please read the manual or ask the manufacturer. Read the safety instructions and warnings before using or charging the LiIon battery.
• Stop using or charging it immediately if it leaks, has a temperature above 70° C or anything else unusual occurs.
• Use only a qualified and specific Li-Po/LiIon charger. Never charge the battery unattended. Do not charge the battery if the charge exceeds 4.2 V / cell. Do not charge the battery with a charging current above 2C. Please check and ensure that you are using a qualified charger. An unqualified charger may cause a fire.
• Do not discharge the battery with a current exceeding the maximum discharge current. Otherwise, this will cause the battery to overheat. This may result in bursting, fire or explosion.
• Never disassemble, puncture, knock, drop, short circuit and/or throw the battery into a fire.
• Improper use such as short-circuiting, or overcharging may result in explosion or fire.
• Keep the battery in a safe place that babies or children cannot reach.
• The above indicates the danger of using the battery. The user assumes full responsibility for the outcome of using the battery

DISPOSAL

• AMEWI is registered below the WEEE Reg. Nr. DE93834722 at the foundation EAR and recycles all used electronic parts properly. Electric and electronical products are not allowed to put in household garbage. Please dispose the product at the end of the lifetime according to the actual laws. You as a customer are responsible by law for the return of all used batteries, a disposal over the household garbage is forbidden!
• Batteries containing hazardous substances are marked with the alongside symbols, which point to the prohibition of disposal in household garbage.
• Additional notations for the critical heavy metal are Cd=Cadmium, Hg=Quicksilver, Pb=lead {Label is placed on the batteries, for example below the bottom left trash symbols).
• Based on RoHS labelling the manufacturer confirms, that all limit values were taken care of at the time of manufacturing
• Batteries labelled with the recycling symbol can be put into used battery collecting tank. {Most supermarkets have)
• They are not allowed to be put into local household garbage
• AMEWI Trade GmbH is involved in the dual system for boxing over the company Landbell AG.
• All used boxes are collected from partner companies {waste disposal contractor) at private customers {local household), sorted and properly utilized. The involvement in a
• Dual Systems helps to save C02 Emissions

THANK YOU

Thank you for purchasing the Amewi HYPER GO Buggy. Please read the instruction manual carefully and keep it for future reference

WARNING

• This remote-controlled model is not a toy. It consists of many small parts and is not suitable for children under 14 years.
• 2x AA batteries are required for the remote control (not included) a 2S 7,4V LiPo battery is used for the car (included).
• Always keep your fingers away from the drive parts and other moving parts to avoid injury.
• The model’s motor gets very hot. To avoid burn injuries, allow the motor to cool for 10-15 minutes after use before touching it.
• Please use only the supplied charger or special multi-function model chargers to avoid damaging the battery.
• Do not look directly into the LED lights.

ON INAPPROPRIATE USE OF THE PRODUCT

• Please do not disassemble or modify the model in any way.
• Please do not use this product improperly or illegally and do not operate it in a manner that could endanger others or yourself.

IMPORTANT NOTICE

Note : This product is manufactured according to strict performance guidelines and complies with safety standards and requirements. This product is not suitable for children under 14 years of age. The manufacturer is not liable for any injury or accident caused using abnormal parts, excessive wear and tear, improper assembly, or operation. Please operate this product safely and responsibly.

PRECAUTIONS

Please read the following safety information before using the model.

• Please do not use the model in an environment that you cannot see.
• Signal interference can cause the model to go out of control. Please do not use the model in the following places:

Warning

• Near a radio tower, mobile phone masts or other places with active radio waves.
• Near crowds or in public places
• Near rivers, ponds or lakes.
• Near electricity pylons or other transmission towers

1. Please do not operate the model if you are tired or unwell, have drunk alcohol or taken drugs – this may cause injury to yourself or others.
2. To avoid burns, never touch drive parts and motors during or immediately after use as they can be very hot.
3. Incorrect operation of the transmitter can cause injury to you or others. Be sure to familiarize yourself with the operation before using the model.
4. Check the model and the remote control before use. Check screws to make sure they are tight.
5. When you have finished using the model, always switch off the model first and then the remote control. Otherwise, the model may get out of control.
6. If the model gets out of range, it may get out of control. Please always stay close to the model with the transmitter.

SWITCH

1. Turn on the power switch of the transmitter, the signal indicator of the transmitter flashes.
2. Press the car’s power switch button on the side of the ESC, the indicator light of the car flashes.
3. When the indicator lights stay on, the connection between remote control and receiver is established.

RECEIVER

Status LED

Indicator situation

| Meanings
---|---
Stays on| Signaled
Flashes| No Signal

Warning : Please make sure the connections are correct

ESC

VCC : Can be used for fans. Please make sure that the required power supply of the fan is suitable for the battery voltage. If you use a 3S LiPo, the voltage requirement of the fan must be approx. 12V. With a 7.4V LiPo at approx. 8V BVD: Receivers with BVD function can be directly connected to this interface through an adapter cable, which is equivalent to connection a battery

THE TRANSMITTER

1. Steering servo (trimmer)
2. CH3 Light control
3. Power Switch (OFF / 70% TH / 100% TH)
4. Indicator light
5. CH1: ST (Steering)
6. CH2: TH (Throttle)

STEERING TRIM

If the vehicle does not drive straight ahead, this can be adjusted using the ST.TRIM knob

POWER/SPEED SWITCH

INDICATOR LIGHT

CH1: ST (STEERING)

CH2: TH (THROTTLE)

Braking: When the car is moving forward, pull the throttle back, the car brakes. Release the throttle and pull it back again, the car moves backwards. Please note that the car has no braking function while driving backwards.

INSTALL THE WHEELIE BAR

Install the wing to the chassis with two screws.

INSTALL TRANSMITTER’S BATTERIES

Open the battery compartment cover of the remote control, insert the 2x AA batteries according to the battery direction, then close the cover.

BATTERY INSTALLATION

1. Turn the battery lock knob, then flip up the cover.
2. Connect the receiver plug to the battery.
3. Put the battery into the battery box and make sure it is installed in place.
4. Flip back the cover and turn the knob to lock

CHARGING THE BATTERY

The battery for the car is a LiPo battery 7.4V 1050mAh 25C. If you charge with a USB charging adapter (not included) with 5V 2A, the charging time is approx. 120 minutes.

• During charging, the green LED on the USB charging cable flashes
• As soon as charging is complete, the LED lights up continuously.
• Immediately remove the battery from the charging cable as soon as charging is complete.

The information on charging time is based on a 5V 2A mains adapter. If you use a different power supply, the charging time will vary. We recommend a power supply unit with 5V 2A output power.

INSTALL THE BODY

Align the 3 holes of the car shell with holders, then install it.

Insert the 3 clips into the holes of body mounts to lock the car body

FRONT SWING SET

REAR SWING SET

DIFFERENTIAL SET

MAIN DRIVING SET

SERVO SET

STEERING

SHOCK ABSORBER

MOTOR SET

amewi.com

References

• Ferngesteuerte Fahrzeuge, Boote, Flugzeuge, Hubschrauber und Panzer - amewi.com
• Ferngesteuerte Fahrzeuge, Boote, Flugzeuge, Hubschrauber und Panzer - amewi.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>