AMEWI 26092 Bait Boat Instruction Manual

AMEWI 26092 Bait Boat Instruction Manual

AMEWI TRADE e.K. Is a young, fresh, international Import and Wholesale company in the RC and Toy industry located in Paderborn. Our product range contains over 6000 articles. Containing to it are Cars, Helicopters, Quadrocopters, Boats and Tanks including a lot of extra parts and all needed spare parts. Our distribution network contains over 600 specialist dealers and online shops.

AMEWI Trade e.K. is an Wholesale Company. We only distribute our goods to
retailers. IF you are an End-Customer who is buying AMEWI-Products , you contract with your retailer.
In case of warranty please always contact your retailer

Declaration of Conformity

This product has been manufactured according to actual technical standards. The product is matching the requirements of the existing european and national guidelines. The Declaration of Conformity has been proofed. AMEWI Trade e.K. declares that this product is matching the basic requirements and remaining regulations of the guideline 2014/53/EU (RED). The declarations and documents are stored at the manufacturer and can be requested and applied there.

The full text of the declaration of conformity can be found at: https://amewi.com/Konformitaetserklaerungen

For additional questions to the product and conformity please contact: Amewi Trade e.K. Nikolaus-Otto-Str. 18, 33178 Borchen or via the website amewi.com

Security and Hazard Warnings

Warning! For damage, caused by disregarding of the manual, warranty expires ! We are not liable for secondary failures, material or personal damage, caused by inproper usage or disregarding the security notices.

Warning! Based on security and registration (CE) reasons, it is forbidden to modify the product personally. Do not disassemble the product.

Warning! Small parts. Danger of suffocation or risk of injury caused by small parts.

Warning! Suitable for people aged 14+ !

Even a drop down from a small height can cause damage to the product.

Battery Notice and Battery Disposal

Warning! Battery do not belong in childrens hands. A change of the battery has to be done by an adult person. Never mix chargable batteries with non-chargable batteries. Never mix fully charged batteries with almost emtpy batteries. Never mix batteries of different capacities. Never try to charge dry batteries. Take care of the correct polarity. Defective batteries belong to special waste. Never leave a charging battery unattended. For questions about the charging time please read the manual or ask the manufacturer.

Disposal

The company AMEWI is registered below the WEEE Reg. Nr. DE93834722 at the foundation EAR and recycles all used electronic parts properly. Electric and electronical products are not allowed to put in household garbage. Please dispose the product at the end of the lifetime accroding to the actual laws. You as a customer are responsible by law for the return of all used batteries, a disposal over the household garbage is forbidden !

Batteries containing hazardous substances are marked with the alongside symbols, which point to the prohibition of disposal in household garbage.

Additional notations for the critical heavy metal are: Cd=Cadmium, Hg=Quecksilver, Pb=lead (Label is placed on the batteries, for example below the bottom left trash symbols).

Based on RoHS labeling the manufacturer confirmes, that all limit values were taken care of at the time of manufacturing.

Batteries labeled with the recycling symbol can be put into used battery collecting tank. (Most supermarkets have) They are not allowed to be put into local household garbage.

AMEWI Trade e.K. is involved in the dual system for boxing over the company Firma Landbell AG. All used boxes are collected from partner companies (waste disposal contractor) at private customers (local household), sorted and properly utilized. The Involvement in a Dual Systems helps to save CO2 Emissions.

TRANSMITTER BATTERIES

Open battery cover

Put in 4 AA batteries, notice correct polarity.

Switch power on, TX LED light is on.
Note: switch on transmitter firstly before switch on boat.

CHARGE BATTERY

Connect first charger to socket. Then connect battery to charger.

The light of the charger turns solid on to indicate charging. The light will turn green after fully charged.

WARNING:
DO NOT leave battery on charge overnight.
DO NOT leave battery unattended during charging.
DO NOT charge battery when battery is inside boat.
DO NOT leave battery plugged into the charger any longer than 6 hours maximum.
It takes around 4 hours to fully charge battery, Disconnect battery with charger after green light is solid on.

Note: Continuously driving time:

1. Fully autopilot driving 3.5 hours.
2. No autopilot driving 2 hours.

PUT BATTERY INSIDE BOAT

Open boat cover

Fix battery with velco strap. Connect battery with receiver plug inside boat.

Switch on power button on rear top of the Boat handle, Power light turns on.
If not use boat for short time, switch off Power button. If not use boat for long time, you must disconnect battery from boat.

OPERATION

Pull the trigger back, the boat moves forward, push the trigger forward, the boat moves backward; rotate the wheel anti-clockwise, the boat turns left, rotate the wheel clockwise, the boat turns right.

Press LED button one time, the night navigation light turns on, press the button again, the night navigation light turns off

If boat steer to right without steering input, press ST/L button to adjust boat run straight.
If boat steer to left without steering input, press ST/R button to adjust boat run straight.

TRANSMITTER & RECEIVER BIND

Switch on transmitter, connect power battery with boat, if RX and BATT. INDICATOR lights don’t turn on, this means you need to bind the transmitter with the receiver. Follow below procedures to bind transmitter and receiver.

Firstly, Make sure transmitter is power off, battery don’t connect with boat.
Secondly press ST/L button and hold, Switch on transmitter, TX light solid on, when GPS ON light flash, let go ST/L button.

Connect battery with boat, Switch on power button on rear top of boat handle. when RX and BATT.INDICATOR lights turn on, now you have bound the transmitter and receiver.

BAIT HOPPER AND REAR LOCK

When the transmitter and receiver of the boat are both turn on, rotate the knob on the transmitter to C. The bait hopper and rear lock are both open.

Attach a metal ring on fishing line, Put the metal ring on rear lock, Rotate the knob from C to
A, the rear lock pin will be extended out to lock the metal ring.
NOTE: This arrangement is used to release the hook. so, when boat take line out, the tension force is on the rear lock.

Put the hook in the hopper through the bottom of hopper door, firstly close the left door, secondly close the right door
(Note: pull fishing line out through the hopper door’s hole.) Thirdly Push down the lock latch.

Put baits inside the hopper.
Rotate the knob from A to C, the hopper door and rear lock will be open to release baits and hook.

GPS AUTOPILOT (nur/only 26082)

Switch on transmitter power first. Then connect battery with receiver plug inside boat, The TX red light and RX green light are both turn on. (Indicate the transmitter and boat are working.

Wait for GPS-ON green light start to flash. (Remarks: It takes about 3-5 minutes, based on circumstances) which indicates the GPS mode on receiver starts working.

Original Point Set Up & One Button Return Function

Control the boat to a spot 10 meters away from the shore.
This location to be the original point that you need to set up.

Press the button GPS-ON on transmitter over 5 seconds.
Green light GPS ON from flash to be solid on, original point is memorized, it is also the home point.

After the boat driven to some distance, Press button GPSON over 1 second, GPSRETURN green light is solid on, the boat will return to the original point automatically.
When arrive at original point, you will hear a beep sound on TX, GPS RETURN light will be off.

Control Priority: When the boat is under the status of one button return automatically, if you pull or push the trigger or rotate the wheel, the boat will cancel return automatically and turn to be controlled by human. Once again if you want to start return automatically, you need to press button GPS ON over 1 second again. then the boat will return automatically.

Fail-Safe Function

When boat is out of control range or you can’t see the boat in lake. You can switch off the transmitter power, after 30 seconds, the Fail-Safe function activated, boat is autopilot driven to original point where you setup. When you can see the boat or boat is within the control range, switch on transmitter, control boat back to shore.

Fishing spot marking function

After the RC boat driven to a location where you want to mark as first fishing spot, press any one of the 4 GPS POSITIONING button over 5 seconds, the green light will be solid on (now you have set up first fishing spot).

If you want boat gets back to the marked fishing spot, Press GPS POSITIONING button over 1 second, relevant red light will be solid on, boat go to marked fishing spot by GPS autopilot.

When the boat arrives at the spot by GPS autopilot, Boat stop, the red light will be off, and transmitter will make beep sound to indicate boat has arrived at the marked fishing spot.

You can set up 4 different fishing spots by pressing the corresponding GPS POSITIONING button over 5 seconds.

If you want to cancel a marked spot, press corresponding button over 5 seconds. Then the green light turns off to show that the fishing spot is cancelled. NOTE: If you are fishing in a new location, you need to cancel all the marked fishing spots and original point where you previously setup in last Fishing location.

LOW VOLTAGE WARNING

When transmitter and RC boat are both power on, the four green lights on the transmitter turn on.

When the power of the battery is running low, the 4 green lights will flash, transmitter will make sound and front and rear navigation light will flash to remind you need to drive the boat back and recharge battery.
NOTE: when BATT INDICATOR lights flash, boat battery will have some power to let you drive boat at least 600 meters.

WATER DRAIN PLUG

Under normal usage situation, the boat is watertight. Should be no water getting inside hull. But if your careless leave hatch open and in the situation of heavy rain or other reason, excessive water inside the hull. You can follow below instruction to disassemble the weed guards and drain the water out easily from hull.

Loose the two screws that hold the two weed guards.

Take out the two weed guards.
Take out the two water drain plugs.

Drain water through the two holes.

Put back the two water drain plugs, place the weed guards on place and tighten the screws.

IMPORTANT USAGE TIPS

1. Setting up the original point is very critical and the basic of GPS one button return and fail-safe function.
   Before you use your boat to delivery bait, you should firstly set up the original point, Refer to manual chapter GPS Autopilot for the correct set up. Neglect of doing this, this boat can’t achieve the GPS one button return and fail-safe function.

2. The transmitter is not waterproof, keep your transmitter away from water, Otherwise, you will be lost control of the boat.

3. When you drive the boat with transmitter, you should keep the transmitter at over 1-meter height to the water surface, this will ensure better radio range and receiving signal. If possible, the higher the better.

4. The transmitter range is 500 meters (depend on weather and circumstance), Transmitter and receiver are bidirectional transmission, the receiver transmission range is 300 meters (depend on weather and circumstance), when boat out of 300 meters range with transmitter, The LED lights on transmitter “BATT.INDICATOR” and GPS autopilot function lights will likely to be flashing or turn off. When you hold your transmitter up in a higher location, you can improve the receiver transmission range and LED lights might be turn on again. (NOTE: the transmitter is still working properly with boat within 500 meters radio range)

5. After each use, open the hatch, let air dry and the moisture is evaporated.

AMEWI Trade e.K.
Nikolaus-Otto-Str. 18
33178 Borchen
Germany
amewi.com
service@amewi.com

AMEWI Trade e.k
Nikolas-Otto-Str. 18
33178

Servicezeiten: Di 9:30 -12 Uhr | Do. 14:00 – 16:30 Uhr
Telefon: +49 180 5009821 (Festnetz 14Ct/M in., Mobil max. 42Ct/M in.) Support:https://amewi.com

USt.4dNr.: DE234941066
Steuernummer: 339 / 5308 / 1578
HRB 4933, Amtsgericht Paderborn

WEEE-Reg.-Nr.: DE 93834722 (Registrierter Hersteler bei der Stiftung Elektro-Alt-Register)

Documents / Resources

| AMEWI 26092 Bait Boat [pdf] Instruction Manual
26092 Bait Boat, 26092, Bait Boat
---|---

References

• Ferngesteuerte Fahrzeuge, Boote, Flugzeuge, Hubschrauber und Panzer - amewi.com
• Ferngesteuerte Fahrzeuge, Boote, Flugzeuge, Hubschrauber und Panzer - amewi.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>