Honeywell 1361 Transformer Wiring for Shared Installation Guide
- June 13, 2024
- Honeywell
Table of Contents
Honeywell 1361 Transformer Wiring for Shared
Honeywell 1361 Transformer
- Model: 1361
Specifications:
- Input Voltage: 110 VAC
- Output Voltage: 16.5 VAC
- Power Rating: 40VA
Product Usage Instructions
-
If the control panel and/or communicator is already powered, remove AC power, then disconnect the battery on each unit.
-
Wire the Honeywell 1361 Transformer as shown below:
-
At the control panel, plug the transformer in.
-
Reconnect the battery at the control panel and the communicator.
Please refer to the online support for further assistance or troubleshooting.
Warranty Information
For the latest warranty information, please visit
http://www.security.honeywell.com/hsc/resources/wa/
Contact Information:
Phone: 800-08251
Address: 2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY
11747
Website: http://www.honeywell.com/security
INTRODUCTION
This guide shows how to wire the Honeywell 1361 Transformer (16.5VAC, 40VA) when it is desired to power both the control panel and the communicator (such as; GSMV, GSMV4G, IGSMV, and IGSMV4G) from one transformer.
IMPORTANT:
- You must use the Honeywell 1361 Transformer.
- This configuration ONLY applies to the VISTA-10P, VISTA-15P, VISTA-20P control panels when used with the GSMV, GSMV4G, IGSMV, and IGSMV4G communicators.
- DO NOT use this configuration with any other control panel.
- DO NOT use this configuration if using two-way voice.
- This configuration has not been evaluated by UL.
To wire the transformer, perform the following steps:
-
If the control panel and/or communicator is already powered, remove AC power, then disconnect the battery on each unit.
-
Wire the Honeywell 1361 Transformer as shown below.
-
At the control panel, plug the transformer in.
-
Reconnect the battery at the control panel and the communicator.
WARRANTY: For the latest warranty information go to: http://www.security.honeywell.com/hsc/resources/wa/
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright
2011 Honeywell International Inc.
www.honeywell.com/security
References
- Commercial Buildings | Honeywell
- Security | Honeywell Building Technologies
- Security | Honeywell Building Technologies
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>