star SM-T400i Series Battery Holder T4 User Manual
- June 6, 2024
- Star
Table of Contents
star SM-T400i Series Battery Holder T4
Information
This manual contains operating instructions and important safety
guidelines. The Battery Holder T4 is designed to charge only the Lithium-Ion
battery pack compatible with the SM-T400i Series Portable Printers.
The contents of this manual are subject to change without prior notice.
Suitable Environment for the Use of the Battery Holder is as Follows:
- Operation Temperature : 0℃ to 40℃ (No Condensation)
- Storage Temperature : -20℃ to 60℃
- Relative humidity : 5% to 95% (No Condensation)
- Altitude : 0 ~ 10,000 feet
- Cooling : Convectional (Non-Vented Case)
Warning / Safety Guidelines
- Keep the charger in a cool, dry place, away from direct sunlight, high temperature, and moisture.
- Do not insert foreign objects into the charger.
- Do not operate the charger if it appears damaged.
- Do not disassemble, incinerate, or short circuit batteries, the charger, or related components.
- Do not operate the charger when your hands or body are wet.
- Do not operate the charger near water.
- To reduce the risk of burn, unplug the charger before cleaning.
- This charger cannot be used for any other types of batteries.
- Use of any charger not approved for the SM-T400i Series can damage the batt eries or the printer and will void the warranty.
- If you do not intend to use the battery pack for a long time, be sure to remove it from the printer, and do not leave it connected to a battery pack holder for exter- nal charging.
- The recharging time depends on the voltage level and ambient temperature of the battery. Normally, it takes about four (4) to five (5) hours to completely re-charge one battery pack.
- The battery is a consumable part that will gradually lose its lifespan over time, depending on the total number of usage hours.
Parts Breakdown
NOTE: This option part “Battery Holder” does NOT include the battery charger.
Using the Battery Holder T4
-
To install battery pack, proceed as follows:
– Insert the battery pack in the direction of the colored arrow. -
To recharge the battery, install the battery pack in the Battery Holder T400.
Insert the DC Plug into the charge connector and plug the AC Cord into a power outlet. -
The T400 Series Battery Pack will begin the charge cycle.
NOTE: Only use the AC Cord approved for the SM-T400i Series. Usage of any other cord can damage the printer, battery, or battery pack and will void the warranty.