teesa TSA3508 Hand Blender Owner’s Manual

teesa TSA3508 Hand Blender Owner’s Manual

Thank you for purchasing TEESA appliance. Please read this operation instruction carefully
before use, and keep it for future use. Producer does not take responsibility for damages caused by inappropriate handling and use of the product.

SAFETY INSTRUCTIONS

In order to reduce the injuries or damages, follow basic safety precautions applied when using any electrical device, including the following:

•  Read this instruction manual carefully, even if you are familiar with the appliance. Keep the manual for future reference.

•  Do not use this device for purposes others than indicated in this manual.

•  Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.

•  Place the device on flat, stable surface.

•  ALWAYS turn off the device and disconnect it from the mains supply:

•  if it’s not operating correctly

•  if there’s an uncommon voice when using

•  before disassembling the device

•  before cleaning

•  when not in use

•  Don’t plug the appliance into the power supply until it is assembled and always unplug before disassembling the appliance or handling the blade.

•  Switch off the device and remove the plug from the socket when it is not in  use, before cleaning or whenever any disturbance occurs. When disconnecting the power cord of the device, grasp and pull the plug, not the cord/cable.

•  Fixed power cable may only be replaced in an authorized service point.

•  Keep the device out of the reach of children. Do not leave children unsupervised with the device.

•  This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised and guided by a person who is responsible for their safety in a cautious manner, and all the safety precautions are understood and followed. Children should not play with this device. Children should not perform cleaning and servicing of the device unsupervised.

•  Test the device and the cord/cable regularly for damage. Before use, make sure the device operates properly. In case of any damage, or if the device does not operate properly, stop using it and unplug immediately.

•  Keep the device and cord/cable away from heat, direct sunlight, water, moisture, sharp edges and the like.

•  Use only original accessories, do not connect incompatible products.

•  The device is for indoor use only.

•  Don’t let the motor unit, cord, or plug get wet. Do not immerse the motor unit in water! Do not handle the device with wet hands.

•  Never use the device if the device itself or its cord have been damaged. Do  not attempt to repair/disassemble this device yourself. In case of damage, contact with an authorized service point for check-up/repair.
  • Don’t let excess cord hang over the edge of the table or worktop or touch hot surface.

•  The appliance is constructed to process normal household quantities. Not for commercial use.

•  Improper use of this device may lead to injuries and damages.

•  Be careful while handling the blades, they are extremely sharp.

•  Keep your fingers and kitchen utensils away from the moving blades.

•  Do not place this device into microwave.

OPERATION

1.  Before assembly, clean all the parts which will have contact with food. Be extremely
   careful when cleaning the blades – they are sharp and can cause injury.

2.  Place the motor unit into the blending stick and turn anti-clockwise until it locks in place

3. Plug the device into power mains socket.

4.  Insert the blending stick into a container with food to be processed.

5.  Press desired speed mode button to start operation.

6.  Use the blender no longer than 1 minute at a time. If within that period, the desired effect has not been reached, stop operation and wait for about 1 minute before using the device again

Note : please regard 1 minute of operation and 1 minute of rest as a one operation cycle.
After continuous operating the device for 5 cycles (that is 1 min. operation followed by 1 minute rest, 5 times in a row), the blender must be left for cooling for about 30 minutes.

7. Unplug the device from power supply mains.

Notes on usage:

•  Don’t use the appliance when not immersed into food.
•  Short-time operating: Use the appliance for no longer than 1 minute at a time; after that let the device cool down for at least 1 minute. Please regard 1 minute of operation and 1 minute of rest as a one operation cycle. After continuous operating the device of 5 cycles (that is 1 min. operation followed by 1 minute rest, 5 times in a row), the blender must be left for cooling for about 30 minutes.
•  Don’t operate hard food for longer than 10 seconds at once.
•  Do not use the appliance for dry grinding hard food like soybean, rice and frozen meat, ice cubes, nutmeg, coffee beans, grains etc., nor for succulent liquid food processing. Don’t operate food without water!
•  Food preparation before processing with the blender: cut the food into cubic blocks no bigger than 1,5×1,5 cm, and add some liquid (e.g. water, milk, etc.).
•  Don’t place the device into hot ingredients. Hot ingredients should be cooled down prior to processing by this appliance. (Max. ingredient temperature is 60°C).

CLEANING AND MAINTENANCE

•  Always disconnect the device from mains supply before cleaning or storing.
•  Motor unit should be cleaned only with soft, slightly damp cloth. Never immerse motor unit into water or any other liquid.
•  After processing very salty food, it is suggested to rise the blades right away.
•  Wash the blending stick in a warm, soapy water. Rinse well.
•  The blending stick can be cleaned in a dishwasher (only if the set temperature is below 50ºC). When cleaning in a dishwasher, be careful not to overdose cleaner or decalcifier. When processing food with color, the plastic parts of the appliance may discolor. Wipe these parts with vegetable oil before placing them in the dishwasher.
•  Cleaning should be performed immediately after use.
•  The blade is very sharp – exercise caution when handling the blade!
•  Let the device dry completely before assembling or storing.

TROUBLESHOOTING

•  The blending stick has not been assembled properly
•  The blade got stuck

|

•  Make sure to assemble the device properly
•  Disconnect the device from power supply mains, and remove the food from the blades – be careful, the blades are very sharp. Take out the food material and cut them into small pieces

The device suddenly stops working in the processing of using| Using for too long, motor is overheated| Use only in time intervals as indicated in this user’s manual
Abnormal vibration or excessive noise|

•  The device has been assembled improperly
•  Too much food being processed at once

|

•  Make sure to assemble the device properly
•  Stop operation, disconnect the device from power supply mains and remove some food being processed

SPECIFICATION

•  2 speed modes
•  Rotation speed:
•  Mode I: max. 14000 rpm
•  Mode II: max. 16000 rpm
•  Used materials:
•  Blades: stainless steel
•  Motor housing: ABS
•  Protection against overcurrent
•  Dishwasher safe parts
•  Weight: 433 g
•  Height: 350 mm
•  Diameter: 62 mm
•  Power cord length: 1 m
•  Max. power: 400 W
•  Power supply: 220-240 V~, 50/60 Hz

English
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)                               

(Applicable in the European Union and other European countries with separate collection systems) This marking
shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local
government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.

Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>