CyberPower GC305UCB 3 Outlet Extension Cord with Surge User Manual

: June 9, 2024
: CyberPower

Table of Contents

FEATURES
SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CyberPower GC305UCB 3 Outlet Extension Cord with Surge -
parts 3-OUTLET
EXTENSION CORD WITH SURGE
(3 AC OUTLETS & 2 USB PORTS)
GC305UCB
USER MANUAL

FEATURES

USB-A Charging Port (1)
USB-C Charging Port (1)
Standard Grounded Outlets (2) and Wide spaced Outlet (1)
Braided Power Cord

EXTENSION CORD INSTRUCTIONS

Plug the extension cord into a standard grounded wall outlet by fully inserting the plug.
Make sure electronic equipment is turned off before plugging into the extension cord outlets.
Do not use extension cords or power strips to connect electronic equipment to this extension cord.

SPECIFICATIONS

Model Number:	GC305UCB
Outlets:	Standard Grounded Outlets (2), Wide spaced Grounded Outlet (1), USB

WARNING: This product can expose you to chemicals including Styrene, which are known to the State of California to cause cancer, and Bisphenol A (BPA), which are known to the State of California to cause birth defects or other reproductive harm.
For more information, go to www.P65Warnings.ca.gov.

CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK:
Use only in dry locations and only indoors.
DO NOT plug into another relocatable power tap.
DO NOT “daisy chain” surge protectors.
DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not available.
DO NOT install this device if there is less than 10 meters (30 feet) of wire between the electrical outlet and electrical service panel.
DO NOT use for medical or life support equipment. This device features an internal protection that will disconnect the surge protective component at the end of its useful life, but it will maintain unprotected power to the load.

FOR MORE INFORMATION
Visit CyberPowerSystems.com for more information regarding:

Product information and certiﬁcations
Product warranty
Connected equipment guarantee

TECHNICAL SUPPORT
Visit: CyberPowerSystems.com/support
Toll-Free: 1-877-297-6937
© 2023 Cyber Power Systems (USA), Inc. All rights reserved.
All other trademarks are the property of their respective owners.

CONFORMANCE APPROVALS
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400 | Shakopee, MN 55379
CyberPowerSystems.com