TROY LIGHTING P7285 McCarthy Outdoor Post Light Instruction Manual

Table of Contents

TROY-LIGHTING-P7285-McCarthy-Outdoor-Post-Light-PRO

DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION

CAUTION

TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached. DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING. In regular circumstances the BLACK wire will be the “Hot” lead wire and the WHITE wire will be the “Neutral” or “Common” lead wire. A GREEN or BARE COPPER wire is the “Ground”. In older buildings it is always good practice to reconfirm the polarity of the wiring.

NOTICE

The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care are factors that cannot be built into any product. Caution and care must be supplied by the person(s) installing, operating and caring for this lighting fixture.
This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through outlet box with a plaster frame. The box must be securely mounted to the structure of the building. The mounting bar and hardware supplied should be used. Directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
NOTE: For your safety be certain that the circuit breakers controlling outdoor lighting and equipment are GFI breakers.

NOTICE: Before discarding the carton, double check to make certain that all parts are found.

Fasten the ground wire to the green or bare copper wire in the outlet box or to the green screw on the crossbar.
Fasten the white fixture lead wire to the white wire in the outlet box. Fasten the wires together with an approved fastener (wire nut). Starting about 1” below the fastener, tightly wrap the connection With electrical tape so that the connection seals the end of the fastener.
WARNING Make sure that there is no exposed wire or strands that could cause a dangerous short circuit!
Connect the black fixture lead wire to the black wire in the outlet box. Fasten the joined wires as in step 2.
Place the fixture on the post and fasten it in place with the set screws provided( in parts bag).
Install the lamp (light bulbs).(not included)
NOTE: This fixture is rated for Max 60 watt type B lamps
Put glass into fixture cage, put the 4 rubber pads (in parts bag) on the top of glass . Lock the fixture roof to fixture cage with 2 allen screws( in parts bag). (Please take away the Styrofoam from the glass before installing.)
Restore power to circuit at breaker or fuse box.