MACKIE CR2-X CUBE Compact Desktop Speakers User Guide

MACKIE CR2-X CUBE Compact Desktop Speakers

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings.
   Install in accordance with the manufacturer’s instructions.

8. Minimum distance (5 cm) around the apparatus for sufficient ventilation.

9. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

10. No naked flame sources, such as lighted candles, should be placed on the apparatus.

11. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

12. Only use attachments/accessories specified by the manufacturer.

13. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

14. Unplug this apparatus during lightning storms or when unused for long periods of time.

15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

16. This apparatus shall not be exposed to dripping or splashing, and no object filled with liquids, such as vases or beer
    glasses, shall be placed on the apparatus.

17.  Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

18. Explanation of symbol, marking, signal lamp or similar means indicates that the apparatus is completely disconnected from the mains.

19. WARNING: Please refer to the information on exterior bottom enclosure for electrical and safety information before installing or operating the apparatus.
    CAUTION
    RISK OF ELECTRIC SHOCK! DO NOT OPEN!
    CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
    REFER SERVICING TO QUALIFIED PERSONNEL.
    The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the prescence of uninsulated “dangerous voltage” within the product’s enclosure, that may be of significant magnitude to constitute a risk of electric shock to persons.
    The exclamation point within an equilateral triangle is intended
    to alert the user of the prescence of important operating and maintaining (servicing) instructions in the literature accompanying the appliance.

20. This device should be installed and operated with minimum distance 20cm between the radiator & your body.

21. Bluetooth transmitter Power: <10dBm
    Bluetooth transmitter frequency range: 2400 – 2483.5 MHz

22. Operating Temperature: 0–45˚ C // 32–113˚ F

WARNING — To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
This equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. Este equipo cumple los límites de exposición a la radiación de la FCC
ISED establecidos para un entorno no controlado.
CAUTION – These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

23. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

    • Reorient or relocate the receiving antenna.
    • Increase the separation between the equipment and the receiver.
    • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
    • Consult the dealer or an experienced radio/TV technician for help.
      CAUTION: Changes or modifications to this device not expressly approved by LOUD Audio, LLC. could void the user’s authority to operate the equipment under FCC rules.

24. This apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the radio interference regulations
    of the Canadian Department of Communications.
    Canada ICES-003(B)/NMB-003(B)

25. This device complies with Part 15 of the FCC Rules [and contains
    license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS standard(s)]. Operation is subject to the following two conditions:

26. This device may not cause harmful interference, and

27. This device must accept any interference received, including interference that may cause undesired operation of the device.

28. Exposure to extremely high noise levels may cause permanent hearing loss.
    Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a period of time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the permissible noise level exposures shown in the following chart.
    According to OSHA, any exposure in excess of these permissible limits could result in some hearing loss. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels use hearing protectors while the equipment is in operation. Ear plugs
    or protectors in the ear canals or over the ears must be worn when operating the equipment in order to prevent permanent hearing loss
    if exposure is in excess of the limits set forth here:

Correct disposal of this product: This symbol indicates that this product should not be disposed of with your household waste, according to the WEEE directive (2012/19/EU) and your national law. This product should be handed over to an authorized collection site for recycling waste electrical and electronic equipment (EEE). Improper handling of this type of waste could have a possible negative impact on the environment and human health due to potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation in the correct disposal of this product will contribute to the effective usage of natural resources. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, waste authority, or your household waste disposal service.

Hookup Diagrams

CR2-X Cube Descriptions

1. Power Connector Connect the supplied power adapter to this jack.

2. Power Switch Turns the CR2-X Cube on and off.
   The front LED will illuminate when powered.

3. USB-C Port An interface allowing you to stream audio to the CR2-X Cube via computer. Connect the USB-C side of a USB cable to the CR2-X Cube and the USB-A side to the computer’s USB port.

4. Line Input Connect a line-level signal using an 1/8″ connector.

5. RCA Connectors (±) Connect the black (–) and red (+) RCA cables from the active speaker’s ± RCA connectors to the passive speaker’s ± RCA connectors.

6. To Sub Connect to a subwoofer using an 1/8″ connector. Note: When connected, the CR2-X Cube automatically shifts to Sub Mode, resulting in a roll-off of the low frequencies.

7. Phones Output Connect stereo headphones here.

8. Volume Tap or slide to adjust the overall output level. The accompanying LEDs display the volume level. Tapping the far left side will mute the output.

9. Input Selector Selects which input – USB, 1/8″ or Bluetooth – is active. The Bluetooth may disconnect when affected by Electrostatic Discharge [ESD]. Manually reconnect the Bluetooth connection.

Getting Started

1. Read and understand the Important Safety Instructions on page 2.

2. Make all initial connections with the power switches OFF on all equipment.

3. Connect the black (–) and red (+) RCA cablesfrom the active speaker’s ± RCA connectors to the passive speaker’s ± RCA connectors.

4. Push the included line cord securely into the CR2-X Cube’s power connector and plug the other end into an AC outlet.

5. Plug signal sources into the CR2-X Cube, such as:
   Line-level source plugged into the line-level input.
   Computer plugged into the USB-C jack.
   Smartphone paired and connected via Bluetooth.

6. Turn the CR2-X Cube on.
   [Rear panel power switch].

7. Be sure that the volume of the input is the same as it would be during normal use.

8. Play an audio file and slowly raise the input and output volumes to a comfortable listening level.

Technical Specifications

58 Hz – 20 kHz

Maximum SPL Peak| ****

103 dB

Coverage Pattern| ****

180˚ horizontal x 180˚ vertical (vertikal)

Total System Power| 60 watts peak

Dynamic Range| ³90 dB
Signal-to-Noise Ratio| ****

³90 dB

Power Requirements| ****

24Vdc, 2.7A

Size (H x W x D)

| ****

6.4 x 4.7 x 6.0 in

163 x 119 x 152 mm

Weight| 6.3 lb / 2.9 kg

All specifications subject to change

WARRANTY AND SUPPORT

Visit WWW.MACKIE.COM to:

• Identify WARRANTY coverage provided in your local market.
  Please keep your sales receipt in a safe place.

• Retrieve a full-version, printable OWNER’S MANUAL for your product.

• DOWNLOAD software, firmware and drivers for your product (if applicable).

• REGISTER your product.

• CONTACT Technical Support.

www.mackie.com

19820 NORTH CREEK PARKWAY #201 • BOTHELL, WA 98011 • USA Phone: 425.487.4333 • Toll-free: 800.898.3211 • Fax: 425.487.4337

Part No. 2055288 Rev. B 08/22 ©2022 LOUD Audio, LLC. All Rights Reserved.
Hereby, LOUD Audio, LLC declares that the radio equipment type [CR2-X Cube] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity and Bluetooth conformity are available at the following internet address: https://mackie.com/en/support/drivers-downloads?folderID=27309

References

• MACKIE
• Drivers/Downloads | MACKIE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>