MACKIE MC-40BT Wireless Headphones with Mic and Control User Guide

: June 5, 2024
: Mackie

Table of Contents

MACKIE MC-40BT Wireless Headphones with Mic and Control
Important Safety Instructions
MC-40BT Wireless Headphones with Mic and Control
- Hookup Diagrams
Quick Start Guide
Technical Specifications
- WARRANTY AND SUPPORT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MACKIE MC-40BT Wireless Headphones with Mic and Control

Important Safety Instructions

Read, follow, and keep these instructions. Heed all warnings.
Do not use in or near dangerous environments. This includes driving, cycling, walking, jogging and other areas where traffic is present and accidents could occur.
Keep this product and its accessories out of reach of children. Handling or use by children may pose a risk of death or serious injury.
Contains small parts and cords that may pose a risk of choking or strangulation.
Set the volume level of the audio device to a minimum, and then, after connecting the earphones, adjust the volume gradually.
Sudden exposure to loud noises could cause hearing damage.
Keep headphones clean. To clean the headphones, wash outside with a mild detergent solution.
Do not attempt to modify this product. Doing so could result in personal injury and/or product failure.
Do not immerse in water, such as while taking a shower, bath, or washing your face. Otherwise, sound deterioration or failures may result.
Do not use while sleeping as accidents may result.
Use a slow twisting motion to remove the earphones. Never pull on the earphone cord.
Stop using the earphones immediately if they are causing great discomfort, irritation, rash, discharge, or any other uncomfortable reaction.
If you are currently receiving ear treatment, consult your physician before using this device.
The use of apparatus is in moderate climates. [115 ˚F / 46 ˚C maximum].
This device complies with Part 15 of the FCC Rules [and contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s license-exempt RSS(s)]. Operation is subject to the following two conditions:
this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.CAUTION: Changes or modifications to this device not expressly approved by LOUD Audio, LLC. could void the user’s authority to operate the equipment under FCC rules.
Exposure to extremely high noise levels may cause permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a period of time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the permissible noise level exposures shown in the chart. According to OSHA, any exposure in excess of these permissible limits could result in some hearing loss.
High sound pressure. Hearing damage risk.
Do not listen at high volume levels for long periods.
WARNING — The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like.
CAUTION — Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Correct disposal of this product: This symbol indicates that this product should not be disposed of with your household waste, according to the WEEE directive (2012/19/EU) and your national law. This product should be handed over to an authorized collection site for recycling waste electrical and electronic equipment (EEE). Improper handling of this type of waste could have a possible negative impact on the environment and human health due to potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation in the correct disposal of this product will contribute to the effective usage of natural resources. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, waste authority, or your household waste disposal service.

MC-40BT Wireless Headphones with Mic and Control

Hookup Diagrams

Conference Call
Traveling
Walking / Running / Working Out
Gaming

MACKIE MC-40BT Wireless Headphones with Mic and Control-
fig6

Quick Start Guide

Descriptions

1/8″ Input Jack This jack allows for a wired connection.
USB C Connector This connector is used for charging the unit.
Status LED This LED indicates the status of the unit, including power, battery level, device pairing and more.
Volume Adjusts the overall output level.
Power / Play / Pause The power button turns the MC-40BT on and off. Press button to play or pause the Bluetooth stream and/or answer and end phone calls.
Read and understand the Important Safety Instructions
on page 2.
Connect a smartphone, tablet or computer to the MC-40BT via Bluetooth. The Bluetooth connection may disconnect when affected by electrostatic discharge (ESD) or electrical fast transients (EFT). If this occurs, manually reconnect the Bluetooth connection.
Your ears are important to us! Be careful of permanent hearing damage. Lower the volume on your device. Even intermediate levels may be painfully loud. Always turn the volume all the way down before connecting the headphones or doing anything new that may affect the headphone volume. Then turn it up slowly as you listen carefully.
Place the headphones over your ears. The power button is located on the right headphone.
Raise the volume on your device up to a comfortably loud listening level and enjoy!
Refer to the owner’s manual for specific button functionality.

Technical Specifications

MODEL MODELO
| ****

MC-40BT

---|---
Frequency Response| ****

20 Hz – 20 kHz

Sensitivity
| ****

102 ±3 dB/mW

Maximum Input Power
| ****

200mW

Impedance| ****

32 Ù

Drive Type
| Dynamic Dinámico Dynamique Dynamisch
Input Type
| 1/8″ TRS and Bluetooth TRS de 3,5 y Bluetooth 3,5 TRS et Bluetooth

TRS-3,5 mm und Bluetooth

Charging Input Voltage| ****

5V

Cable Length| Audio

47.2 in 1199 mm

| USB

11.8 in 300 mm

Weight Peso| ****

0.7 lb ±10%

0.3 kg ±10%

WARRANTY AND SUPPORT

Visit WWW.MACKIE.COM to:

Identify WARRANTY coverage provided in your local market.
Please keep your sales receipt in a safe place.
Retrieve a full-version, printable OWNER’S MANUAL for your product.
DOWNLOAD software, firmware and drivers for your product (if applicable).
REGISTER your product.
CONTACT Technical Support.