MACKIE OnyxGO Mic Wireless Clip-On Mic With Companion App User Guide

MACKIE OnyxGO Mic Wireless Clip-On Mic With Companion App

IMPORTANT SAFETY INSTRUCTIONS

1. Read, follow, and keep these instructions. Heed all warnings.

2.  Do not expose to extreme cold or heat.

3.  Do not expose to rain, use it in water, or in damp or wet conditions.

4.  Do not expose to any excessive dust and other foreign particles.

5.  Keep clean by washing outside with a dry cloth.

6.  Never attempt to disassemble.

7.  Mackie cannot be held responsible for any damage caused by improper use or modifications.

8.  This device complies with Part 15 of the FCC Rules [and contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s)]. Operation is subject to the following two conditions:

9.  this device may not cause harmful interference, and

10.  this device must accept any interference received, including interference that may cause undesired operation. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences
    et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

11.  l ’appareil ne doit pas produire de brouillage, et

12.  l ’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and the receiver.

•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.
  CAUTION: Changes or modifications to this device not expressly approved by LOUD Audio, LLC. could void the user’s authority to operate the equipment under FCC rules. Exposure to extremely high noise levels may cause permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a period of time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the permissible noise level exposures shown in the chart. According to OSHA, any exposure in excess of these permissible limits could result in some hearing loss:

• WARNING The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire, or the like.

• CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

• This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End-user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value was reported under this standard during product certification.

Hookup Diagrams 

FRONT, SIDE, TOP & BOTTOM PANEL DESCRIPTIONS

1.  USB C Connector This connector is used for charging the unit.
2.  Internal Mic Built-in mic for immediate use.
3.  Phones Jack This 1/8″ connector supplies the output to stereo headphones.
4.  Status LED This LED indicates the status of the unit, including battery level, device pairing, recording status, and more.
5.  Record/Power Switch This switch turns the unit on/off, activates Bluetooth pairing, and allows for remote start/stop recording (among other functions) and more.

GETTING STARTED

1.  Read and understand the Important Safety Instructions on page 2.
2.  Connect a smartphone or tablet to the OnyxGO Mac via Bluetooth.
3.  Open the OnyxGO app and adjust gain, EQ, FX, noise reduction, video parameters (and more) to taste.
4.  Start recording by clicking the side button on the OnyxGO Mic or record on the device.
5.  Talk, sing, or play the instrument at the same volume as it would be during normal use… and keep it going![If necessary, simultaneously adjust the levels and other parameters.].
6.  End recording by clicking the side button on the OnyxGO Mic or stop on the device.

TECHNICAL SPECIFICATIONS ESPECIFICACIONES TÉCNICAS CARACTÉRISTIQUES TECHNIQUES TECHNISCHE DATEN

WARRANTY AND SUPPORT

•  Identify WARRANTY coverage provided in your local market. Please keep your sales receipt in a safe place.
•  Retrieve a full-version, printable OWNER’S MANUAL f or your product.
• DOWNLOAD software, firmware, and drivers for your product (if applicable).
•   REGISTER your product.
• CONTACT Technical Support.

References

• MACKIE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>