Honeywell HH400 Handheld 2D Area-Imagining Scanner User Guide
- June 4, 2024
- Honeywell
Table of Contents
Honeywell HH400 Handheld 2D Area-Imagining Scanner
Note: Refer to your user’s guide for information about cleaning your device.
Getting Started
Turn off computer’s power before connecting the scanner, then power up the computer once the scanner is fully connected.
Power Supply Assembly (if included)
Connecting the Scanner USB
RS232 Serial Port:
Reading Techniques
The viewfinder projects an aiming beam that should be centered over the bar
code, but it can be positioned in any direction for a good read.,
Hold the scanner over the bar code and center the aiming beam on the barcode.
The aiming beam is smaller when the scanner is closer to the code and larger
when it is farther from the code. Hold the scanner close to smaller bar codes,
and farther away from large bar codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need to tilt
the scanner at an angle so the bar code can be scanned.
Standard Product Defaults
The following bar code resets all standard product default settings.
Note: Default setting do not change product interface type. Ex: Keep USB interface no change after default setting.
Programing the interface
HH400 support interface type of RS232 and USB HID. Change cable and scan one
of the following barcode to program your interface.
-
RS232 COM port
Scan following barcode to program interface to RS232 COM Port with RS232 cable. -
USB Keyboard port
Scan following barcode to program interface to USB keyboard port with USB cable.
Enter/Change line setting
- Add Enter
- Cancel Enter
- Add change line
- Cancel change line
Technical Assistance
Contact information for technical support, product service, and repair can be found at www.honeywellaidc.com.
User Documentation
For localized versions of this document, and to download the User’s Guide, go
to www.honeywellaidc.com.
Limited Warranty
For warranty information, go to
www.honeywellaidc.com and click Resources>
Warranty.
Pantents
For patent information, see www.hsmpats.com.
Disclaimer
Honeywell International Inc. (“HII”) reserves the right to make changes in
specifications and other information contained in this document without prior
notice, and the reader should in all cases consult HII to determine whether
any such changes have been made. The information in this publication does not
represent a commitment on the part of HII.
HII shall not be liable for technical or editorial errors or omissions
contained herein; nor for incidental or consequential damages resulting from
the furnishing, performance, or use of this material. HII disclaims all
responsibility for the selection and use of software and/or hardware to
achieve intended results.
This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of HII.
Copyright 2015-2016 Honeywell International Inc. All rights reserved.
Web Address: www.honeywellaidc.com
Names and Content of Hazardous Substances in the Product)
(Indicates that this hazardous substance contained in at least one of the homogeneous materials for this part is above the limit requirement in China’s GB/T26572 .)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>