SCOSCHE BASE3 MS Charging Stand User Guide
- June 9, 2024
- Scosche
Table of Contents
BASE3 MS Charging Stand
User Guide
BASE3 MS Charging Stand
iPhone 12 or later (with optional Magsafe Case)
iPhone 12 or Later (without Case)
PD 18W or Higher (Charger not included)
FCC Statement
This device complies with part 15 of the FCC Rules. Operations subject to the following two conditions:
- This device maynot cause harmful interference , and
- This device must accept any interference received, including interference that may cause undesired operation .
This equipment has been tested and found to comply with the limits for a Class B digital devicpursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, usesInd can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION : To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules , this device must be used with certified
peripherals and shielded cables . All peripherals must be shielded and
grounded. Operation with non-certified peripherals or non-shielded cables may
result in interference to radio or reception.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the
equipment .
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body
ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
BASE3 MS How-to Video…
Scosche Industries
1550 Pacific Avenue
Oxnard, California 93030
Phone: 800-363-4490
x1/805-486-4450 x 1
www.scosche.com
©2022 Scosche Industries
Scosche BASE3 MS are trademarks of Scosche Industries.
Other marks or brands are the property of their respective owners.
Devices and or appearance may vary.
Designed in Oxnard, California
SI MSQP 5/22
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>