Marshall Drivemaster Re-Issue Pedal User Guide

: June 9, 2024
: Marshall

Table of Contents

CONGRATULATIONS ON PURCHASING YOUR MARSHALL DRIVEMASTER PEDAL
GETTING STARTED
SPECIFICATIONS
CONTROLS
WA RRANTY
Documents / Resources

Marshall Drivemaster Re-Issue Pedal

![Congratulations On Purchasing Your

Marshall Drivemaster Pedal](https://manuals.plus/wp-content/uploads/2023/03 /Marshall-Drivemaster-Re-Issue-Pedal-User-Guide-1-Copy.png)

CONGRATULATIONS ON PURCHASING YOUR MARSHALL DRIVEMASTER PEDAL

The Drivemaster is based on the original Guv’nor, but takes things a stage
further with a new tone and drive network to push performance levels
even higher. Where most pedals give at best just two tone controls, the
Drivemaster’s three band tone network acts as if adding an extra amp to your
set up, with real Marshall tone and overdrive.

The iconic look has also been accurately recreated, right down to the finish of the control knobs and unique shape. There’s plenty of reasons the first edition is so heavily sought after today. This reissue takes everything that made the original so special and replicates it for today’s player.

We hope you enjoy your new pedal as much as we have enjoyed designing and building it for you.

– The Marshall Team

GETTING STARTED

This device requires power from either a 9V battery or a 9V DC power adaptor:

To fit a battery, remove the compartment cover on the underside of the pedal. Insert the battery, connect it to the terminals and replace the compartment cover. Remove the battery from the pedal when not in use.
When selecting a power adaptor for your pedal, ensure it is compatible with both the pedal and your mains supply. Your Marshall dealer can help you with this.

Warning: unsuitable power adaptors may produce unwanted noise or damage your pedal.

SPECIFICATIONS

Model no.	PEDL-00103
Description	Distortion pedal
Inputs/Outputs	1 x 1/4” jack input, 1 x 1/4” jack output
Controls	Gain, Bass, Middle, Treble and Volume
Power	9VDC regulated, centre negative, 5.5mm x 2.1mm or Standard 9V

CONTROLS

Controls

The pedal is active when the LED above the footswitch is illuminated. Press the footswitch again to deactivate the pedal.

Gain: Sets the pre-distortion level.
Bass: Use this control to dial in a low-end boost.
Middle: Use this control to boost or scoop the mid frequencies.
Treble: Use this control to dial in a high-end boost.
Volume: Controls the output level of the pedal (post-distortion).

WA RRANTY

For warranty information and to register your product please visit:
marshall.com/register-your-marshallamp

Whilst the information contained herein is correct at the time of publication, due to its policy of constant improvement and development, Marshall Amplification Plc reserves the right to alter specifications without prior notice.

MARSHALL AMPLIFICATION PLC, DENBIGH ROAD,
BLETCHLEY, MILTON KEYNES,
MK1 1DQ, ENGLAND.
T: +44 (0) 1908 375411
MARSHALL AMPLIFICATION PLC
REGISTERED IN ENGLAND REGISTERED NUMBER: 805676
M3311.447 | CATS-00265-02-v04