FoMaKo BH201 Camera and IP Controller User Guide
- June 9, 2024
- FoMaKo
Table of Contents
FoMaKo BH201 Camera and IP Controller
Dear Friend,
Thanks for ordering from FoMaKo. To setup your PTZ streaming system easier,
please read this quick start instruction first.
Important Information
The camera&controller PTZ system bundle has been optimized, don’t need change your PC’s network settings or download software to your PC, very easy to setup. Some Information about this PTZ System:
- Cameras & IP PTZ controller enabled DHCP by default
- IP Controller default control protocol is“Sony Visca”
- Under Sony Visca, it can search FoMaKo cameras which added to your LAN
- Sony Visca port: 52381 , IP Visca port: 5678 ,Onvif Port: 2000 ,user name: admin, Password: admin
PTZ System Connection
Please check the following picture, we recommend to connect the devices like this:
Find Cameras’ and IP PTZ controller’s IP address
- Power on cameras and IP controller, your router will assign IP address for them.
- On IP controller’s screen, it will show controller’s IP address
- Press “search” button on controller, it will show FoMaKo cameras’ IP address on the screen
- Now, you can login webpage by camera/controller’s IP
- We recommend to disable DHCP when you login camera/controller’s webpage, because if you keep DHCP enable, when power off and power on camera again,the IP address will be changed
Add cameras to IP PTZ controller
we recommend to use Sony Visca or IP Visca control protocol, functions are better than Onvif
- Under “Sony Visca” control protocol, press “search” button
- Choose camera’s IP address, press “enter” button
- Input camera’s control ID(1~255 numbers) and press “enter” to confirm
- To add the second or more cameras, just press “search” again and step by step to add
Any questions please contact us at [email protected], normally, we can reply in 12hours.
Read User Manual Online (PDF format)
Loading......