ARDESTO CVC-D0611BB Cordless Vacuum Cleaner Instruction Manual

June 9, 2024
ARDESTO

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner

IMPORTANT SAFEGUARDS

When using an electrical appliance, the following rules of use and precautions should always be followed:

  • Read all instructions carefully before use.
  • Remove all packing materials and stickers before use.
  • This is a vacuum cleaner for dry cleaning, do not use it to suck liquid to avoid being damaged.
  • Do not immerse the charger or vacuum cleaner into the water for cleaning to avoid any risk.
  • Do not use appliance on or near an open fire or on a heated oven.
  • Make certain that the ventilation slits of the appliance are not covered in case affect radiating heat.
  • Do not use the appliance to suck flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
  • Do not use the vacuum cleaner on large objects, sharp objects or building materials.
  • Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the charger.
  • Do not use the appliance with damaged charger, cord or plug.
  • The appliance can only be powered by the charger provided. Do not use the charger to charge any other appliance. The device must only be powered by safety extra-low voltage, as marked on the device.
  • When the device is not in use, before cleaning, before assembling or disassembling, turn off the device and turn off the power supply of the charger to avoid electric shock.
  •  Before cleaning, cut off the power source of charger to avoid electric shock.
  • Do not use the appliance if the charger cord is damaged. If the appliance or charger fails, take the appliance to an authorized service center for inspection, repair or adjustment.
  • Do not disconnect the battery for use other than as intended. This appliance contains a battery that should only be replaced by qualified personnel.
  • The battery should not be disposed of with household waste. If the battery can no longer be used, it must be disposed of properly. Never throw it into a fire, as an explosion may occur.
  • This appliance can be used by children over the age of 8 and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they are under constant supervision or instructed in the safe use of the appliance and understand the possible dangers. Children should not play with the appliance. Cleaning and customer service should not be performed by children without supervision.
  • Careful supervision is necessary if the appliance is used by or near children.
  • Use of accessories not recommended by the manufacturer may result in malfunction and personal injury.
  • Do not operate the appliance for other than its intended use.
  • Do not use outdoors.
  • When use the floor brush, please take care to avoid inhalation of power supply cord, curtain and other similar objects which maybe twine around the brush.
  •  Fully charge the new battery before first use.
  • Remove the plug from the socket when the vacuum cleaner is fully charged. Do not unplug the device from the outlet by pulling on the cord.
  • Do not leave the operating device unattended.
  • Any repairs to the device must be carried out by the manufacturer or authorized service center.
  • This appliance is intended for use in domestic and similar environments, including:
    •  kitchen areas for staff in shops, offices and other production environments, on agricultural farms;
    • customers in hotels, motels and other residential type infrastructure;
    • in private boarding houses.
  • The device is not intended to be operated from an external timer or a separate remote-control system.

FOR HOUSEHOLD USE ONLY

EQUIPMENT

  • Cordless vacuum cleaner – 1 pc
  • Turbo brush – 1 pc
  • Nozzle for upholstered furniture – 1 pc
  • Crevice nozzle – 1 pc
  • Compact universal nozzle – 1 pc
  • Wall mount – 1 pc
  • Charger – 1 pc
  • User manual (contains warranty card) – 1 pc

PRODUCT DISPLAY

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 1

  1. Roller turbo brush
  2. Aluminum Tube Assy
  3. Nozzle for upholstered furniture
  4. Dust Cup
  5. Filter Holder
  6. HEPA Filter
  7. Main Unit (Contain Battery Pack)
  8. Charger
  9. Wall mount
  10. Long Crevice nozzle
  11.  Compact Universal nozzle

PRODUCT ASSEMBLY

Main unit, components and accessories are packed separately for convenient transportation and storage. Users should follow the steps below for assembling when they use the product for the first time.

Aluminum tube and brush connection

Attach the aluminum tube NO.1 to the brush connector NO.2 as shown on figure 2 until the release button NO.3 clicks as shown on figure 3, then they are in place properly.

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 2

Aluminum Tube And Main Unit Assembly

Attached aluminum tube assy NO.1 toge their with brush to the air inlet of main unit NO.2 as show until release button NO.3 clicks. See figure  NO.2 as s4 and 5.how

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 3

Installing wall mount

Fix the wall mount (NO.2) on the wall by punching 4 pieces of M4*20 taper screws (small pack of attachment) on grooves (Ne1) (see Fig.6). Fig.7 shows the status of the wall mount after fixed. The long crevice tool (NO.3) and brush for upholstered furniture (NO.4) can also hang on the wall mount when they are not in use, as figure 8.

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 4

OPERATING INSTRUCTION

Overall Unit
Press the power switch NO.1 to switch on the vacuum, as figure 9; Clean the floor or carpet when rolling brush works, and press the power regulation button NO.2 to change turbo or normal level, the initial setting is turbo. Press again the power switch N0.1 if you want it to stop; Pay attention to the battery power level LED(NO.3). When the battery power is full, it shows 100%. The screen can show the battery percentage while using, and when it shows 09%, which means the power is used off, the vacuum cleaner will stop.

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 5

Main Unit Operation

Press release button NO.1 to disassemble aluminum tube and brush; Press the button NO.2 to switch on the vacuum for cleaning furniture, bed or wall; and press the power-control button NO.3 to switch turbo and normal level. Press again the power switch NO.2 if you want it to stop; Please be advised that battery LED screen NO.4 displays 100% if fully charged. The screen can show the battery percentage while using, and when it shows 0%, which means the power is used off, the vacuum cleaner will stop.

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 6

Turbo brush is equipped with a safety which will ensure that it shuts itself off if, for example, objects which are too large are sucked up, or if fingers become tangled in the floor brush. This is for personal safety and to protect the motor. To restart the floor brush, press 2 times the on/off button or the power regulation button.

Battery disassemble operation

Hold the main unit, pressing the release button NO1 and NO2 at the same time and pull out the battery, as fig.15.

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 7

Nozzles
All nozzles can match with main unit or aluminum tube assy., as figure 16-21.

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 8 ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 9

BATTERY CHARGING

Charging mode: as shown in fig. 22, hang the main unit to the wall mount, the hook NO.1 on the wall mount can hold the groove NO.2 at the bottom of the unit. And then plug the charger to the main unit. The LED screen of the battery is on during charging and it 100% after fully charged. Charging time is to 4-5 hours. ill show

ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 10

Attention: The vacuum cleaner is unable to start when charging.

CLEANING AND MAINTENANCE

  1. Push the release button NO.1 to remove the dust cup NO.2 from main unit.

  2. To remove the HEPA filter, pull on the protrusion of the filter labeled «UP»

  3. To remove the filter holder, open the dust box cover on the other side and turn the filter holder counterclockwise.

  4. Shake out the dirt from the HEPA filter, filter holder and dust box. Ihe HEPA filter must not be washed! The dust container and filter holder can be washed under the tap, then dried completely.

  5. To assemble, follow steps 1-3 in reverse order.

  6. If the brush bar is jammed during use, press the No.7 brush roller release button and rotate the No. 8 brush holder, the brush will automatically pop out, and then pull it out.
    To remove hair from the brush, run the blade of the scissors along the groove to cut the hair, pull it out, and then reinsert it into the floor brush. Fig. 25

  7. To quickly clean the HEPA filter, rotate the No. 9 dust cleaning knob. After use, dust adheres to the surface of the HEPA filter, rotating the knob may cause dust to fall out of the dust box.ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 14

  8. To quickly empty the dust bin: Hold the vacuum cleaner over the trash can. Lightly pull the special lever No. 10 towards you – the cover of the dust box No. 11 will open down, after which the dirt inside the dust box will fall into the trash can.ARDESTO CVC-D0611BB Cordless Vacuum Cleaner 15

  9. The main unit (except for the battery pack), turbo brush and aluminum tube can be wiped with a slightly damp cloth. Do not immerse the device in water or other liquids. The battery pack can only be cleaned with a dry cloth.

NOTE: It is recommended to clean the dust cup after every use. If the ilter holder and HEPA filter is blocked caused by the cumulation of dust, please clean or replace it in time. The electric roll brush may be wrapped with some hair or other dirt after long time use, so please clean it in time to make the appliance work efficiently.

PROBLEM AND SOLUTION

  • The device does not start up: The battery is empty. Charge the device.
  • The device does not vacuum: The filters are dirty/the dust reservoir is full. The floor nozzle is clogged/the floor brush is blocked. Clean the device as described in this manual.
  • The running time of the device is shorter and shorter: The device is not sufficiently charged. Charge the device fully and try again. The battery is broken or old. Contact the after sales service. Stuck hairs. Remove the hairs stuck on the brushes.

ELECTRICAL PARAMETERS

  • Working voltage: DC 25.2V
  • Rated power: 150W
  • Battery Charger Input: 100-240 V50/60 Hz
  • Battery Charger Output: 32 V, 450 mA
  • Electrical Brush Rated Power: 15 W

ENVIRONMENT-FRIENDLY DIPOSAL

Never dispose of the device with normal household waste. Dispose of the device through an authorized disposal company or an appropriate government agency. Please follow all applicable rules. If in doubt, contact your waste disposal company. Your local community or municipal government can provide information on how to properly dispose of the product. This device is powered by a recyclable lithium-ion battery. When the device reaches the end of its useful life, remove the battery from the device before disposing of it. Dispose of the battery in accordance with local waste disposal requirements. If you have questions about disposal, please contact your local waste disposal agency. The packaging is recyclable. Dispose of the packaging environmentally.

Warranty conditions

The plant guarantees normal operation of the product within 12 months from the date of the sale, provided that the consumer complies with the rules of operation and care provided by this Manual. Service life of the product is 3 years. In order to avoid any misunderstanding we kindly ask you to carefully study the Owners Manual, the terms of warranty, and check the correctness of filling the Warranty Card. The Warranty Card is valid only if the following information is correctly and dearly stated: model, serial number of the product, date of sale, clear seals of the company- seller, signature of the buyer. The model and serial number of the product must correspond to those specified in the Warranty Card. f these terms are violated, and if the information specified in the Warranty ard is changed, erased or rewritten, the Warranty Card is considered invalid. Setup and installation (assembly, connection, etc.) of the appliance are described in the attached documentation; they can be carried out both by the user, and by specialists having the necessary qualification sent by USC or selling companies (on a paid basis). In this case, the person (the institution) installing the appliance shall be responsible for the correctness and quality of installation (setup). Please pay attention to the importance of the correct installation of the appliance, both for its reliable operation, and for obtaining warranty and free service. Require the installation specialist to enter all the necessary information about the installation in the Warranty Card. In case of failure of the appliance during the warranty period by the fault of the manufacturer, the owner is entitled to free warranty repair upon presentation of the correctly filled Warranty Card together with the appliance in the factory configuration packed in the original packaging to the warranty workshop or the place of its purchase. Satisfaction of the customer’s claim due to the fault of the manufacturer shall be made in accordance with the law «On Protection of Consumers’ Rights». In the case of warranty repair the warranty period shall be extended for the period of repair and shipment.

WARRANTY CARD

Dear Buyer! Congratulations on your purchase of the ARDESTO brand appliance, which was designed and manufactured in accordance with the highest quality standards, and we thank you for choosing this particular instrument. We ask you to keep the coupon during the warranty period. When purchasing a product, require a full warranty card.

We ask you to keep the coupon during the warranty period. When purchasing a product, require a full warranty card.

  1. Warranty service is carried out only if there isa correctly and clearly filled original warranty card, which indicates: product model, date of sale, serial number, warranty service period and the seller’s seal.*
  2. The service life of household appliances is 3 years.
  3. The product is intended for consumer use. When using the product in commercial activities, the seller/ manufacturer does not bear warranty obligations, after-sales service is performed on a paid basis.
  4. Warranty repair is carried out within the period specified in the warranty card for the product in an authorized service center on the conditions and terms determined by applicable law.
  5. The product is withdrawn from the warranty in case of violation by the consumer of the operating rules set forth in the instruction manual.
  6. The product is removed from warranty service in the following cases: misuse and non-consumer use; mechanical damage damage caused by the ingress of foreign objects, substances, liquids, insects; damage caused by natural disasters (rain, wind, lightning, etc), fire, domestic factors (excessive humidity, dust, aggressive environment, etc.) damage caused by non-compliance of power and cable network parameters with state standards and other similar factors; when operating equipment in the power supply network with a missing single ground loop; in case of violation of seals installed on the product lack of serial number of the device, or inability to identify it
  7. The warranty does not cover consumables and accessories, as well as filters, shelves, drawers, stands and other containers for storing products.
  8. The warranty period is 12 months from the date of sale. Tear-off maintenance tickets are provided by an authorized service center

The completeness of the product is checked. I have read the terms of the warranty service, no complaints.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals