ARDESTO CVC-X0621WB Cordless Vacuum Cleaner Instruction Manual

ARDESTO CVC-X0621WB Cordless Vacuum Cleaner Instruction Manual

IMPORTANT SAFEGUARDS

When using an electrical appliance, the following rules of use and precautions should always be followed:

• Read all instructions carefully before

• Remove all packing materials and stickers before

• This is a vacuum cleaner for dry cleaning, do not use it to suck liquid to avoid being

• Do not immerse the charger or vacuum cleaner into the water for cleaning to avoid any

• Do not use appliance on or near an open fire or on a heated

• Make certain that the ventilation slits of the appliance are not covered in case affect radiating

• Do not use the appliance to suck flammable or combustible liquids, such as gasoline, or use in areas where they may be

• Do not use the vacuum cleaner on large objects, sharp objects or building

• Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the

• Do not use the appliance with damaged charger, cord or

• The appliance can only be powered by the charger Do not use the charger to charge any other appliance. The device must only be powered by safety extra-low voltage, as marked on the device.

• When the device is not in use, before cleaning, before assembling or disassembling, turn off the device and turn off the power supply of the charger to avoid electric

• Before cleaning, cut off the power source of charger to avoid electric

• Do not use the appliance if the charger cord is If the appliance or charger fails, take the appliance to an authorized service center for inspection, repair or adjustment.

• This unit contains a non-replaceable battery. Do not disconnect the battery for use other than as This appliance contains a battery that should only be replaced by qualified personnel.

• The battery built into this unit should not be disposed of with household If the battery can no longer be used, it must be disposed of properly. Never throw it into a fire, as an explosion may occur.

• This appliance can be used by children over the age of 8 and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they are under constant supervision or instructed in the safe use of the appliance and understand the possible Children should not play with the appliance.
  Cleaning and customer service should not be performed by children without supervision.

• Careful supervision is necessary if the appliance is used by or near

• Use of accessories not recommended by the manufacturer may result in malfunction and personal

• Do not operate the appliance for other than its intended

• Do not use

• When use the floor brush, please take care to avoid inhalation of power supply cord, curtain and other similar objects which maybe twine around the

• The Sub-unit is use only with this appliance, and this appliance is not applicable any other sub-unit.

• Fully charge the new battery before first

• Remove the plug from the socket when the vacuum cleaner is fully Do not unplug the device from the outlet by pulling on the cord.

• Do not leave the operating device

• Any repairs to the device must be carried out by the manufacturer or authorized service

• This appliance is intended for use in domestic and similar environments, including:

  • kitchen areas for staff in shops, offices and other production environments, on agricultural farms;
  • customers in hotels, motels and other residential type infrastructure;
  • in private boarding

• The device is not intended to be operated from an external timer or a separate remote-control

HOUSEHOLD USE ONLY

EQUIPMENT:
Cordless vacuum cleaner – 1 pc Turbo brush – 1 pc
Nozzle for upholstered furniture – 1 pc Crevice nozzle – 1 pc
Charging base – 1 pc Adaptor – 1 pc
User manual (contains warranty card) – 1 pc

DEVICE DESCRIPTION

1. Dust cup
2. Filter holder
3. HEPA filter
4. Sub-unit
5. Body
6. Handle
7. Charging base
8. Adaptor
9. Floor turbo brush 10 Crevice nozzle
10. Brush for upholstered furniture

INSTALLATION INSTRUCTION

The body, other components and accessories are packed separately for convenient transportation and storage. The users shall install the appliance by following the operation as below when use at the first time. Assembling of Body and Handle
To insert the Handle (1) to Body (3) along the direction shown on Fig. 2. And then fasten the Bolt (2) to the body (3) bolt socket along the direction shown on Fig. 3 so that the Handle can be locked into the Body safely. Assembling of Body and Floor Brush
To insert the Floor Brush (1) to the Body along the direction shown on the Fig. 3 until the Lock Button (2) locks

Charging base: install the charger and charger stand

Insert the charger into charger stand (see Fig. 4), after it, use the screws attached to fix the whole unit onto the wall or put in on a horizontal surface.

OPERATION INSTRUCTION

Operate the whole unit

There are two switches including power switch (1) and power regulation button (2) (see Fig. 5). Press down power switch (1), the motor starts to run, the floor brush indicator turns on and the appliance enters into working condition; Press down the power regulation button (2), the cleaner will change to the Turbo Mode in which it achieves a much better cleaning performance on a hard-to-clean surface. Once the power regulation button is press again, the cleaner will change back to the Normal Mode in which the cleaner will have a longer running time. Press the power switch (1) if you want to make the appliance stop working. During operation, please pay attention to charge quantity indicators (3), the indicators will extinguish gradually as the charge quantity reduces and the appliance will stop working automatically when all the indicators extinguish.

Operate the sub-unit (detachable handheld vacuum cleaner)

Press down the sub-unit release button (4) (see Fig. 6), grasp the handle of sub-unit to remove it by following the arrow shown, and then press down the sub-unit switch (5) (see Fig. 7), the sub-unit
enters into working condition, and you can press the switch (5) to make it stop working.If need to use brush for upholstered furniture, please insert it into the suction nozzle of sub-unit by following Fig. 7, and then activate it again; If need to use crevice nozzle, insert it into the suction nozzle of sub-unit by following Fig. 7, and then activate it again.

CHARGING INSTRUCTION

1. Insert the small plug of the adapter into the charger stand, then connect the power adapter to the mains (see 8).
   

2. Lift the appliance and put it onto the charger, make the socket of body (1) cover the charger stand (2), at that time the electricity
   quantity indicator turns on, and the appliance enters into the charging condition, all the charging indicators will turn on when finish charging. (see Fig. 9).

NOTE: The appliance can not be activated during charging process.

CLEANING AND MAINTENANCE

1. Detach the accessory on the sub-unit, and then press the release button (1) to make dust cup(2) be seperated from the sub-unit (see 10).
   

2. Grasp the filter handle (3) and remove the filter assemblyGrasp the filter handle (3) and turn it counterclockwise to separate the filter holder (6) from the HEPA filter (5) (see 13-14).
   

3. Clean the HEPA filter. The HEPA filter must not be washed! The filter holder can be washed under the tap, then wipe and dry completely.
   

4. After cleaning the dust cup assembly, please install the HEPA filter into the filter holder firstly and then put them into the dust cup, after it, install the dust cup into the sub-unit (see Fig. 15).
   

5. If hair found on the floor brush, press the roll brush release tab (7) as shown below to open the roll brush cover, and then remove the roll brush (8) (see 16-17).

6. To remove hair from the brush, run the blade of the scissors along the groove to cut the hair, pull it out, and then reinsert it into the floor
   

NOTE: It is recommended to clean the duct cup after every use. If the filter holder and HEPA filter are blocked caused by the cumulation of dust, please clean or replace it in time. The electric roll brush may be wrapped with some hair or other dirt after long time use, so please clean it in time to make the appliance work efficiently.

PROBLEM AND SOLUTION

The device does not vacuum.

| The filters are dirty/the dust cup is full. The floor nozzle is clogged/the floor brush is blocked.

Clean the device as described in this manual.

The running time of the device is shorter and shorter.

| The device is not sufficiently charged. Charge the device fully and try again. The battery is broken or old. Contact the after sales service.

Stuck hairs. Remove the hairs stuck on the brushes.

ELECTRICAL PARAMETERS

ENVIRONMENT-FRIENDLY DIPOSAL

Never dispose of the device with normal household waste. Dispose of the device through an authorized disposal company or an appropriate government agency. Please follow all applicable rules. If in doubt, contact your waste disposal company.
Your local community or municipal government can provide information on how to properly dispose of the product.

This device is powered by a recyclable lithium-ion battery. When the device reaches the end of its useful life, remove the battery from the device before disposing of it. Dispose of the battery in accordance with local waste disposal requirements. If you have questions about disposal, please contact your local waste disposal agency.
The packaging is recyclable. Dispose of the packaging environmentally.

Warranty conditions:

**** The plant guarantees normal operation of the product within 12 months from the date of then sale, provided that the consumer complies with the rules of operation and care provided by this Manual.
Service life of the product is 3 years. In order to avoid any misunderstanding we kindly ask you to carefully study the Owner’s Manual, the terms of warranty, and check the correctness of filling the Warranty Card. The Warranty Card is valid only if the following information is correctly and clearly stated: model, serial number of the product, date of sale, clear seals of the company- seller, signature of the buyer. The model and serial number of the product must correspond to those specified in the Warranty Card.If these terms are violated, and if the information specified in the Warranty Card is changed, erased or rewritten, the Warranty Card is considered invalid.
Setup and installation (assembly, connection, etc.) of the appliance are described in the attacheddocumentation; they can be carried out both by the user, and by specialists having the necessary qualification sent by USC or selling companies (on a paid basis). In this case, the person (the institution) installing the appliance shall be responsible for the correctness and quality ofinstallation (setup). Please pay attention to the importance of the correct installation of the appliance, both for its reliable operation, and for obtaining warranty and free service. Require the installation specialist to enter all the necessary information about the installation in the Warranty Card. In case of failure of the appliance during the warranty period by the fault of the manufacturer, the owner is entitled to free warranty repair upon presentation of the correctly filled Warranty Card together with the appliance in the factory configuration packed in the original packaging to the warranty workshop or the place of its purchase. Satisfaction of the customer’s claim due to the fault of the manufacturer shall be made in accordance with the law «On Protection of
Consumers’ Rights». In the case of warranty repair the warranty period shall be extended for the period of repair and shipment.

Read More About This Manual & Download PDF:

References

• Компания ERC: Сервис-центр(СЕРВІСНИЙ ЦЕНТР)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>