Joie Kubbie Travel Cot Instruction Manual
- June 9, 2024
- Joie
Table of Contents
Joie Kubbie Travel Cot
Welcome to Joie™
-
Congratulations on becoming part of the Joie family! We are so excited to be part of your lifewith your little one. While using the Joie
-
Kubbie™, your baby is enjoying a high quality, fully certified travel cot, approved to European safety standards EN 716-1:2017+AC:2019. This product is suitable for use with children weighing under 15kg (approximately 0-4 years).Please carefully
read this manual and follow each step to ensure a comfortable sleeping and best protection for your child. -
Please keep the Instruction Manual handy for future reference.
-
Visit us at Joiebaby.com to download manuals and see more exciting Joie products.
-
For warranty information, please visit our website at joiebaby.com
! IMPORTANT RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
Emergency
In case of emergency or accident, it is most important to have your child taken care of with first aid and medical treatment immediately
Parts List
Make sure all parts are available before assembly. Accessories may be sold separately or may not be available depending on region. If any part is missing, please contact local retailer. No tools are required for assembly.
- Travel Cot
- Mattress
- Carry Bag
- Long Rail
- Corner
- Foot
- Wheel
- Folding Webbing
- Latch Button
- Short Rail
- Connecting Tube
- Bassinet
WARNING
- Adult assembly required.
- Discontinue using travel cot when child reaches 15kg (approximately 86cm in height) or is able to climb out.
- Discontinue using bassinet when child can sit, kneel or roll over or pull itself up.
- The lowest position of the mattress is the safest and the base shall always be used in that position as soon as the baby is old enough to sit up.
- Do not use the cot if any part is broken, torn or missing and use only spare parts approved by the manufacturer.
- Do not use more than one mattress in the travel cot.
- DO NOT leave anything in the travel cot or place the travel cot close to another product, which could provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blind curtain cords etc.
- Be aware of the risk of open fire and other sources of strong heat such as electric bar fires, gas fires, etc in the near vicinity of the travel cot.
- All assembly fittings should always be tightened properly and that fittings should be checked regularly and retightened as necessary.
- The cot is ready for use only when the locking mechanisms are engaged and to check carefully that they are fully engaged before using the folding cot.
- Only use the mattress sold with this cot, do not add a second mattress on this one, suffocation hazards.
- To prevent injury from falls that when the child is able to climb out of the cot, the cot shall no longer be used for that child.
Travel Cot Assembly
Please read all the instructions in this manual before setting up and using this product.
- Undo the two hook and loop fasteners. 1
- Pull the short rails up until both become rigid. If not rigid, pull up again until they are rigid. 2
- If short rails do not latch, raise the center of floor halfway up, and then pull up again to latch the rails.
- Latch the long rails. 3
- Push the center of floor down. 4
- Be sure all rails have locked before lowering center.
- Assemble the connecting tubes. 5
- Install mattress. 6
- Install mattress, soft side up.
- Use wheels, see images 6 – 1
Fold Travel Cot
-
Remove the mattress. 8
-
Pull the folding webbing upward. 9
Do not unlock rails yet. Center of floor must be halfway up before rails will unlock. -
Unlock all four rails by following these steps.
-
Slightly lift the center of the rails. 10
-
Squeeze the latch button on the rail to release the two tubes. 10
* Do not force fold.
* Both tubes must be released for the rail to fold, if rail does not fold completely, please lift the center of floor higher, and then try again from step 3.- Fold the unit, but do not force. 11
- If unit will not fold, look for a partially latched rail. Squeeze the latch button to release the rail.
- Wrap the travel cot with the mattress. Guide the hook and loop fasteners through the rings and attach them. 12
Cover Travel Cot
Cover the travel cot by following these steps.
- Place the mattress, with handle facing the zipper on the carry bag.
- Cover unit with carry bag 13 , and then zip together. 14
- Pull the handle out from carry bag. The carry bag and the travel cot will be lifted together.
Bassinet Assembly
Tip Before setting up bassinet, make sure all rails have become rigid.
The bassinet must be fully assembled and installed before using, including 8
bassinet clips and mattress.
- Position the bassinet clips over and down into the edges of the travel cot. 15
- Be sure all bassinet clips are secured in place by pushing down firmly on each bassinet clip until all are snapped into place.
- Assemble the connecting tubes. 16
- Place the mattress into the bassinet. 17
- Place mattress, soft side up.
- The installed bassinet is shown as 18
Care and Maintenance
- The covering material is not removable.
- Your travel cot can be spot cleaned with a sponge and soapy water.
- Do not use undiluted neutral detergent, gasoline or other organic solvent to wash the travel cot. It may cause damage to the travel cot.
- To wash carry bag, machine wash in lukewarm water and drip-dry. Do not use bleach.
- At the beach or in the garden, clean sand and grit off your travel cot. Sand in the long rail locks may cause damage.
- From time to time, check your travel cot for worn parts, torn material or stitching. Replace or repair the parts as needed.
- If the travel cot is not in use for a long period of time, please put it in the shade where your child cannot access it.
ABOUT COMPANY
- Allison Baby UK Ltd,
- Venture Point, Towers Business Park
- Rugeley, Staffordshire, WS15 1UZ
- NUNA International B.V.
- Van der Valk Bourmanweg 178 C,
- 2352 JD Leiderdorp, The Netherlands