DINAN D760-0061 Turbo Inlet Pipe Instruction Manual
- June 4, 2024
- DINAN
Table of Contents
DINAN D760-0061 Turbo Inlet Pipe
Thank you for being selective enough to choose a Dinan Performance Turbo
Inlet. The Dinan Engineering Team has spent many hours developing this product
to assure that you will receive increased performance, durability and an
aesthetic design that you as a customer will be able to enjoy for many years.
Ease of installation and maintenance is important to us and has been highly
considered throughout the design process.
Prior to performing the installation, familiarize yourself with these
instructions as it should help you with the process. If you feel that you do
not have the required skills or tools, please arrange for a qualified repair
facility to perform the installation.
If you have any difficulties during the installation, or if these instructions
are not clear to you, please call Dinan’s Technical Support Staff at
800-341-5480. Again, thank you for
choosing Dinan. Enjoy.
PARTS LIST
- [ D763-0184 ] TURBO INLET ASSY; B58
TOOLS REQUIRED
Basic hand tools such as screwdrivers (including bits such as Torx), pliers,
and picks are required; no specialty tools are required.
INSTALLATION
-
STEP 1:
Unclip the air mass flow sensor harness from the sensor. Push down and back on the small grey tab; the clip should release with an audible ‘click’. Detach the connector from the sensor.
-
STEP 2:
Release the four clips securing the airbox lid.
-
STEP 3:
Follow the outlet of the airbox down to the hose clamp near the turbo inlet; loosen this hose clamp. Remove the stock air intake assembly.
Note: If accessing this clamp is difficult, and additional clearance is needed, you may release the hose clamp by the mass air flow sensor and remove the upper airbox lid. If further clearance is needed, you may remove the lower air box.
Note: The turbo inlet is now exposed. Items which fall inside can cause significant damage to the turbo!
-
STEP 4:
Disconnect the two electrical connectors from the turbo inlet.
-
STEP 5:
Disconnect the two stacked EVAP line fittings from the turbo inlet.
-
STEP 6:
Disconnect the PCV breather line fitting from the valve cover.
-
STEP 7:
Disconnect the turbo inlet spring clip and remove the turbo inlet.
-
STEP 8:
Transfer the sealing ring and spring clip from the OEM turbo inlet to the Dinan turbo inlet.
Note: The orientation of the sealing ring is critical for safe operation of the engine. The sealing ring must be installed to match the OEM orientation. Incorrect installation may result in damage to the turbo, intercooler, engine, or other related components.
-
STEP 9:
Transfer the heated PCV valve from the OEM turbo inlet to the Dinan turbo inlet
-
STEP 10:
Install the Dinan turbo inlet.
Note: Ensure that the spring clip is fully seated for proper functionality of the turbo inlet.
-
STEP 11:
Connect the PCV breather line fitting to the valve cover.
-
STEP 12:
Connect the two stacked EVAP line fittings to the turbo inlet.
-
STEP 13:
Connect the two electrical connectors to the turbo inlet.
-
STEP 14:
Install the intake, following the disassembly steps in reverse order.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>