cell2 CR06 LED Flush Mount Kit User Manual
- June 9, 2024
- Cell2
Table of Contents
cell2 CR06 LED Flush Mount Kit
WIRING
*Actual approval will be based on the model purchased.
OPERATION
For Simultaneous or Alternating Flash
-
Apply +VDC to RED and YELLOW wires simultaneously to enter GROUPING MODE;
lighthead will display short (single or double) flashes:
• Single flash = Group 1
• Double flash = Group 2 -
Remove YELLOW wire from +VDC then momentarily apply +VDC to change Groups:
• Lightheads of the same Group will flash together.
• Lightheads of different Groups will flash alternately. -
Save and Exit the GROUPING MODE by powering off the lighthead.
For Flash Pattern Selection
While in Warning Mode, momentarily apply +VDC to YELLOW wire:
- once to next pattern
- quickly three times to FP#1
FLASH PATTERNS
1| Double| [R65*]
2| Single| [2Hz]
3| Triple| [2Hz]
4| Quad| [2Hz]
5| Random
6| Steady EF**
7| Single| [SAE][CA13]
8| Double| [SAE]
9| Triple| [SAE]
10| Quad| [SAE]
11| Quint| [SAE]
12| Mega
13| Giga
14| Ultra| [SAE]
15| Single-Quad
16| Singe H/L
17| Single-Triple-Quint
Actual approval will be based on the model ordered.
For use with external flasher controller.
INSTALLATION
Pop-n-Lock
Recommended Surface thickness @1.5~4.0mm
-
Select a mounting location and drill an 1.14” (29mm) cut-out, and then install the LIGHTHEAD onto the cut-out.
NOTE: To install more efficiently, use a rotating motion to guide the LIGHTHEAD when installing onto the cut-out.
-
Ensure that the optical stripes are aligned vertically.
-
Where necessary, apply silicone around the reverse side to prevent from rotating.
*Bracket Mount (sold-separately)**
-
From the front, install the LIGHTHEAD onto the BRACKET.
NOTE: To install more efficiently, use a rotating motion to guide the LIGHTHEAD when installing onto the BRACKET.
-
Ensure that the optical stripes are aligned vertically.
-
Secure the BRACKET onto the desired mounting surface with screws.
-
Where necessary, apply silicone around the reverse side to prevent from rotating.
