wallbox SI Pulsar Max Multilingual Electric Vehicle Charger Instruction Manual

: June 9, 2024
: wallbox

Table of Contents

wallbox SI Pulsar Max Multilingual Electric Vehicle Charger Instruction
Safety and Maintenance Instructions
Simplified EU declaration of conformity
Safety Recommendations
Connector Recommendations and Installation Instructions
Installation Instructions
Electrical Protection
Disposal Advice
Limited Warranty
Legal Notice
For more information on setting up your charger, visit the Wallbox
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

wallbox SI Pulsar Max Multilingual Electric Vehicle Charger Instruction

Manual

Safety and Maintenance Instructions

Installation, maintenance, & servicing of the charger must be performed only by qualified personnel per the applicable local Unauthorized installation and modifications make the manufacturer warranty void • Do not use if the enclosure or connector is broken, cracked, opened, or shows any indication of damage. Please contact your distributor • Do not touch the charging cable if the connector emits smoke or begins to melt.

If possible, stop charging • Power off the charger before opening the cover or cleaning the unit. Do not use cleaning solvents on any part of the charger. Use a clean, dry cloth to remove dust and dirt. Do not open the cover in rain • Take appropriate precautions with electronic medical implants • Use the Wallbox charger under the operating parameters and within normal ambient conditions specified in the General and Electrical Specifications. • Ventilation not supported • It is not recommended to install the charger in

a position that has direct sunlight or under extreme weather conditions.

Simplified EU declaration of conformity

Hereby, Wallbox declares that the equipment (Pulsar Max) is in compliance with Directive 2014/53/EU, Directive 2014/30/EU and Directive 2014/35/EU. The full text of the EU declaration of conformity is available at the following internet address:
https://support.wallbox.com/en/knowledge-base/ce-declaration/

Safety Recommendations

Follow all the safety and installation instructions carefully Failure to follow instructions may be a safety hazard and/or cause equipment malfunction • Any resulting damage due to disregard or actions contrary to the instructions in this manual is excluded from the product warranty.

Connector Recommendations and Installation Instructions

Do not use if the charging cable is frayed, has broken insulation, or has any signs of damage or the vehicle plug or electrical outlet is dirty, wet, or damaged Do not use the charging cable with a cable adaptor or an extension cable • Under any circumstances, do not tighten the charging cable while it is connected • It is mandatory use the plug holder provided with the unit to protect the connector from dirt and other weather elements and from slipping during usage.

Installation Instructions

Watch the installation video for your charger available at the Wallbox Academy web page: https://support.wallbox.com Ensure that the mounting surface can adequately support the weight

of the charger and withstand mechanical forces associated with usage • The charger must be permanently connected to the electrical Earth of the installation • Install the charger in a sufficiently ventilated area. Avoid installing the charger near flammable, explosive, or combustible materials, chemicals or solvents, gas pipes or steam outlets, radiators or batteries, and areas prone to flooding, high humidity and running water.

Electrical Protection

The power supply line must be wired to an existing installation and be in accordance with local • The charger must be electrically protected by installing externally a Miniature Circuit Breaker (MCB) and a Residual Current Device (RCD). • MCB:

C curve, 6kA rated short-circuit capacity. Rated current to be established at 1,25 times the minimum value between power supply and charger setting (i.e. 16A version with MCB 20A, 32A version with MCB 40A) • RCD: According to local regulations, Type A or Type B. Manual reset type only. • Local regulations may require an emergency switch to be installed externally.

Disposal Advice

In accordance to the Directive 2012/19/EC, at the end of its useful life, the product should not be disposed of as urban It should be taken to a collection center or to a distributor that provides disposal of special and differentiated waste.

Limited Warranty

Wallbox warrants this product against defects in materials and workmanship for a period of 3 years from the date of purchase
During this period, at its discretion, Wallbox will either repair or replace any defective product at no charge to the owner • Replacement products or repaired parts will be guaranteed for

only the unexpired portion of the original warranty or six months whichever is greater. • Any defect resulting from any accident, misuse, improper maintenance, or normal wear and tear is not covered by the limited warranty • Substitution or incorporation of any part by the client will be considered as incorrect usage • Except to the extent permitted by applicable law, the terms of

this limited warranty do not exclude, restrict, or modify, and are in addition to, the mandatory statutory rights applicable to the sale of the product to you. If you believe your product is defective, contact Wallbox for instructions on where to send or bring it for repair.

Legal Notice

Any information in this manual may be changed without prior notice and does not represent any obligation on the part of the Images in this manual are for illustration purposes only and might differ from the delivered product.