Cell2 STEALTHMAX 6+6 Lead Dual Colour Lighthead User Manual
- June 9, 2024
- Cell2
Table of Contents
Cell2 STEALTHMAX 6+6 Lead Dual Colour Lighthead
WIRING
OPERATION
For Flash Pattern Selection
Each Warning Memory may select and save one flesh pattern. While activating a warning mode, momentarily apply YELLOW wire to +VDC:
- Once to next pattern
- Quick three times to FP#1 (refer to Flash Pattern Chart)
For Simultaneous or Altematlng Synchronization
- Enter SETTING MODE by powering up with YELLOW and RED (or WHlTE or RED+WHUTE) Wires simultaneously; the light head will display short flashes (single or double)
- Single flash = Group 1
- Double flash = Group 2
- Remove the YELLOW wire from +VDC then momentarily apply to +VDC again for more than 3 seconds to change Groups:
- Lightheads of the same Group will flash together.
- Lightheads of the different groups will flash alternately.
- Save and exit the SETTING MODE by disconnecting all power.
NOTE: All warning memories share the same Group setting.
For Colour Mode Setting
- Each Warning Memory may select and save one Colour Mode. Enter SETTING MODE by powering up with YELLOW and RED (or WHTE or RED+WHIUTE) wires simultaneously; the lighthead will display its current Colour Mode
- Single Colour flashing Colour 1 = Colour 1
- Single Colour flashing Colour 2 = Colour 2
- Dual Colour flashing Colour 1 = Colour 1 alt. 2
- Dual Colour flashing Colour 2=Colour 2 alt. 1
- Remove YELLOW wire from +VDC then momentarily apply to +VDC again for less than 3 seconds to change Colour Mode.
- Save and exit SETTING MODE by disconnecting all power.
For Cruise Mode Setting
- While activating the cruise mode, momentarily apply YELLOW wire to +VDC to select colour 1 or colour 2.
Flash Pattern
| 1 | Double | [R65] |
|---|---|---|
| 2 | Single | [2Hz] |
| 3 | Triple | [2Hz] |
| 4 | Quad | [2Hz] |
| 5 | Random | |
| 6 | Steady EF | |
| 7 | Single | [SAE/CA13] |
| 8 | Double | [SAE] |
| 9 | Triple | [SAE] |
| 10 | Quad | [SAE] |
| 11 | Quint | [SAE] |
| 12 | Mega | |
| 13 | Giga | |
| 14 | Ultra | [SAE] |
| 15 | Single-Quad | |
| 16 | Single H’L | |
| 17 | Single-Triple-Quint | |
| 18 | Steady Scene | |
| 19 | Single-Single | |
| 20 | Double-Double | |
| 21 | Triple–Triple Md | |
| 22 | Triple-Triple Fast | |
| 23 | Quint-Triple | |
| 24 | 7-1 Flash | |
| 25 | 7-1 Flash | |
| 26 | Quad-Single | |
| 27 | Quad Single | |
| 28 | Cluint-Cluint |
FP#19-28 will always operate in dual colour
- Actual approval will be based on the model ordered.
- For use with external flash controller Inverted colour mode.
86-MO7310-0001.2
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>