Cell2 12-24VDC 6-Led Narrow Profile Lighthead Installation Guide
- June 9, 2024
- Cell2
Table of Contents
24VDC 6-Led Narrow Profile Lighthead
Installation Guide
12-24VDC 6-Led Narrow Profile Lighthead
Wiring / Operation Connect YELLOW wires of all heads together for
synchronization. (All heads should be set to the same pattern)
For Simultaneous or Alternating Flash:
-
Apply +VDC to RED and YELLOW wires simultaneously to enter
Grouping mode; lighthead will display short (single or double) flashes: Single flash = Group1 Double flash = Group2 -
Remove YELLOW wire from +VDC and momentarily apply to +VDC to change Groups:
Heads in the same Group flash together. Group1 heads alternate with Group2 heads.
For Flash Patterns:
Momentarily apply +VDC to
YELLOW wire:
- once for next pattern
- quick three times to reset to FP#1
NOTE:
- This unit may not be factory-set at FP#1.
- Please double check lighthead orientation before mounting for FP# 22.
| Flash Patterns
---|---
1| Double [R65]| 13| Single H/L (split)
2| Single [2Hz]| 14| Single [SAE]
3| Triple [2Hz]| 15| Double [SAE]
4| Quad [2Hz]| 16| Quad [SAE]
5| Random| 17| Quint [SAE]
6| Single (split)| 18| Mega
7| Double (split)| 19| Ultra [SAE]
8| Quad (split)| 20| Single-Quad
9| Quint (split)| 21| Single H/L
10| Mega (split)| 22| Steady Half
11| Ultra (split)| 23| Steady All
12| Single-Quad (split)|
*split = Left alternating Right
Installation
Universal Bracket (Multi-Angle) NOTE: Please mount the lighthead according to the mounting style puchased.
- Graphs only show horizontal illustration.
L-Bracket (Front / Rear)
Documents / Resources
|
Cell2 12-24VDC 6-Led Narrow Profile
Lighthead
[pdf] Installation Guide
12-24VDC, 12-24VDC 6-Led Narrow Profile Lighthead, 6-Led Narrow Profile
Lighthead, Narrow Profile Lighthead, Profile Lighthead, Lighthead
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>