Cell2 AL6 Wide Angle Lighthead User Manual

Cell2 AL6 Wide Angle Lighthead

Surface Mounting

WIRING

OPERATION

For Simultaneous or Alternating Flash:

1. Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode; lighthead will display short (single or double) flashes:
   Single flash = Group1
   Double flash = Group2

2. Remove YELLOW wire from +VDC then momentarily apply +VDC to change Groups:
   Heads of the same Group will flash together.
   Heads of different Groups will flash alternately.

3.  Save and Exit the Grouping Mode by powering off the lighthead.
   For Flash Patterns:
   Momentarily apply +VDC to YELLOW wire:
   once for next pattern
   quick three times for FP#1
   NOTE: This unit may not be factory set at FP# 1.

FLASH PATTERNS

1| Double [R65]| 9| Double [SAE]
2| Single [2Hz]| 10| Triple [SAE]
3| Triple [2Hz]| 11| Quad [SAE]
4| Quad [2Hz]| 12| Quint [SAE]
5| Random| 13| Ultra [SAE]
6| Steady| 14| Single-Quad
7| Single [SAE][CA13]| 15| Single H/L
8| Mega [SAE]| 16| Singe-Triple-Quint

Side Mirror Mounting

ADJUSTABLE RANGE FOR SIDE MIRROR MOUNT

1. Up-down tilting: ±8°
2. Left-right tilting: ±8°
3. Height Adjustment: 8mm

Side Mirror Mounting

Notes when Mounting with back Cover

• Please ensure that the wires should exit from the side without the groove A

• Please break away the drainage notch B with pliers. (Not required for pedestal mount)

1. Select a mounting location and install the Bracket 1 to mirror.

2. Attach the Bracket 2 to the Lighthead.

NOTE: You may adjust the height and Left-Right tilting at this point.

3. Feed the wires through the cable grommet and assemble the Bracket 1 with Bracket 2.

NOTE: You may adjust the Up-down tilting at this point.

4. Secure the back Cover with the screw and the rubber stud.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>