Cell2 SL209 Exterior Scene Light User Manual
- June 9, 2024
- Cell2
Table of Contents
Cell2 SL209 Exterior Scene Light
SL209 Exterior Scene Light Manual
WIRING:
INSTALLATION
-
Place the foam pad onto the desired mounting surface and mark the location for the two mounting screws and the wire routing hole location between the two screw holes
Note: Please refer to the illustration below to ensure the exact location for wire routing. -
Drill two 06.35 (0.25″) pilot holes for plastic screw grommets and one for wire routing. Then refer to the exploded-view drawing shown to install two washers and two self-tapping screws properly. Self-tapping screw
Note: Deburr the wire routing hole thoroughly before feeding the wire. -
Feed the wires through the foam pad and wire routing hole and mount the scene light with the supplied self-tapping screws.
Note: Apply silicone around the mounting holes and wire routing hole for sealing if necessary.
MOUNTING DIMENSIONS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>