Cell2 EGION-FIT Legion FIT Cruise (H002) Speaker User Manual
- June 9, 2024
- Cell2
Table of Contents
Cell2 EGION-FIT Legion FIT Cruise (H002) Speaker
WIRING & FUNCTIONS
(AM/AN)
Different applications require different functions. It is highly recommended to determine and configure the required functions prior to Installation; (refer to ‘CONTROL WIRES’ section).
LIGHTBAR WIRING
Functions are activated by applying +VDC to a control wire
POWER WIRES
- Route Power Cable to the vehicle firewall towards the battery.
- Follow factory wiring harness through the firewall. It may be necessary to drill a hole in the firewall. Ensure that there are no components that could be damaged from the drilling.
- Route the cable to the battery.
- Install a fuse (user-supplied) on the end of RED wire, then connect to battery.
- Connect BLACK wire to the factory chassis ground adjacent to the battery.
NOTE : make sure that all wires of power ca b l e a r e securely connected to power source
CONTROL WIRES
- Route Control wires towards the dash area to a switch panel (user-supplied).
- Connect the required wires to the switch panel
WARNING MODE
Activate Warning Mode by applying +VDC to RED wire. There is a list of built-
in flash patterns to choose from. While in Warning Mode, tap +VDC to YELLOW
wire:
- Once for next pattern.
- Quickly 3 times for FP#1.
FP#| FLASH PATTERN
---|---
1| Double (corners) R65
2| Double (all) 2Hz
3| Double (split) 2Hz
4| Quad (all) 2Hz
5| Quad (split) 2Hz
6| Single (all) 2Hz
7| Single (split) 2Hz
NOTE : For ECE-R65 mode, FP#1 should be used
DIM MODE
If desired, the bar can be switched to DIM Mode. While Warning Mode is activated, apply +VDC to YELLOW wire continuously to switch to DIM Mode. Simply remove +VDC from YELLOW wire to de-activate.
CRUISE MODE
- Activate Cruise Mode by applying +VDC to WHITE wire. patterns to choose from. While in Cruise Mode, tap +VDC to YELLOW wire:
- Once for next Cruise Mode Module Selection.
- Quickly 3 times for factory setting Cruise Mode.
NOTE : Cruise Mode factory setting is corner modules only.
web : www.cell2.com
email : sales@cell2.com
tel : +44(0)2033285 494
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>