cell2 LP6 LED Pad User Manual
- June 9, 2024
- Cell2
Table of Contents
LP6 LED Pad
User Manual
Surface Mount
NOTE: When using
adhesive mount, ensure that the mounting surface is clean, dry and well
unified before mounting.
Connect BROWN wires of all heads together for synchronization.
(all heads should be set at the same flash pattern)
For Simultaneous or Alternating Flash:
-
Apply +VDC to WHITE and BROWN wires simultaneously to enter Grouping mode; the light head will display short (single or double) flashes:
• Single flash = Group1
• Double flash = Group2 -
Remove BROWN wire from +VDC and momentarily apply to +VDC to change Group:
• Heads of the same Group flash together.
• Group1 heads alternate with Group2 heads.
For Flash Patterns:
Momentarily apply +VDC to BROWN wire:
- once for next pattern
- quick three times for pattern 1
NOTE: This unit may not be factory-set at FP#1.
| FP# | Flash Patterns |
|---|---|
| 1 | Single |
| 2 | Double |
| 3 | Triple |
| 4 | Quad |
| 5 | Random |
| 6 | Single (Split) |
| 7 | Double (Split) |
| 8 | Quad (Split) |
| 9 | Quint (Split) |
| 10 | Mega (Split) |
| 11 | Ultra (Split) |
| 12 | Single-Quad (Split) |
| 13 | Single H/L (Split) |
| 14 | Single |
| 15 | Double |
| 16 | Quad |
| 17 | Quint |
| 18 | Mega |
| 19 | Ultra |
| 20 | Single-Quad |
| 21 | Single H/L |
| 22 | Steady Half |
| 23 | Steady All |
*Split = Left alternating Right
CAUTION
Over tightening the mounting screws could damage the light head and void the
warranty.
Use an in-lb torque wrench, tighten the mounting screws with the suggested
range of torque value: For #6 mounting screws – 6 to 7.8 in-lbs.
86-M4510-0011.0
Documents / Resources
|
cell2 LP6 LED
Pad
[pdf] User Manual
LP6, LED Pad, LP6 LED Pad, Pad
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>