cell2 LP4 LED PAD User Manual
- June 9, 2024
- Cell2
Table of Contents
cell2 LP4 LED PAD User
Surface Mount
(All heads should be set to the same pattern)
NOTE : To obtain optimum adhesion, the surfaces must be clean, dry and well unified
For Simultaneous or Alternating Flash
- Apply +VDC to WHITE and BROWN wires simultaneously to enter Grouping mode; lighthead will display short (single or double) flashes:
- Single flash = Group1
- Double flash = Group2
- Remove BROWN wire from +VDC and momentarily apply to +VDC to change Groups:
- Heads in the same Group flash together.
- Group1 Heads alternate with Group2 Heaads
For Flash Patterns
Momentarily apply +VDC to BROWN wire:
- once for next pattern
- quick three times to reset to FP#1
NOTE : This unit may not be factory set at FP#1.
Flash Patterns
| 1 | Single (2Hz) | 13 | Single H/L (split) |
|---|---|---|---|
| 2 | Double (2Hz) | 14 | Single (all) (SAE) |
| 3 | Triple (2Hz) | 15 | Double (all) (SAE) |
| 4 | Quad (2Hz) | 16 | Quad (all) (SAE) |
| 5 | Random | 17 | Quint (all) (SAE) |
| 6 | Single (split) | 18 | Mega (all) |
| 7 | Double (split) | 19 | Ultra (all) (SAE) |
| 8 | Quad (split) | 20 | Single-Quad (all) |
| 9 | Quint (split) | 21 | Single H/L (all) |
| 10 | Mega (split) | 22 | Steady Half |
| 11 | Ultra (split) | 23 | Steady All |
| 12 | Single-Quad (split) |
- SPLIT = Left alternating Right
- ALL=Simultaneous
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>