cell2 86-M4310-0011.0 Mini Lighthead Instruction Manual
- June 9, 2024
- Cell2
Table of Contents
cell2 86-M4310-0011.0 Mini Lighthead Instruction Manual
Surface Mount
For Synchronization:
Connect BROWN wires of all heads together for synchronization (All heads
should be set at the same Flash Pattern)
For Simultaneous or Alternating Flash:
-
Apply +VDC WHITE and BROWN wires simultaneously to enter Grouping mode;
light head will display short (single or double) flashes:- Single flash = Group1 • Double flash = Group2
-
Remove BROWN wire from +VDC and momentarily apply to +VDC to change Groups:
- Heads in the same Group flash together.
- Group1 Heads alternate with Group2 heads.
For Flash Pattern, momentarily apply + VDC to BROWN wire:
- once for next pattern
- quick three times to reset to FP#1 (see flash pattern chart)
NOTE: This unit may not be factory-set at FP#1.
FP#|
Flash Patterns
---|---
1| Random| 7| Quad (SAE)
2| Steady| 8| Quint (SAE)
3| Single (SAE) (CA13)| 9| 8 Flash (SAE)
4| Mega| 10| Single-Quad
5| Double (SAE)| 11| Single H/L
6| Triple (SAE)| 12| Single-Triple-Quint
CAUTION
Overtightening the mounting screws could damage the light head and void the
warranty.
Use an in-lb torque wrench, tighten the mounting screws with the suggested
range of torque value:
For #6 mounting screws – 6 to 7.8 in-lbs.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>