cell2 LP26 LED PAD Instructions
- June 9, 2024
- Cell2
Table of Contents
cell2 LP26 LED PAD
WIRING
- CAUTION: Ensure that the mounting surface is evenly flat; mounting this light head on non-flat surfaces may result in bending and/or water ingress.
- NOTE: When using an adhesive mount, ensure that the mounting surface is clean, dry, and well-unified before mounting.
OPERATION
For Flash Patterns:
Momentarily apply +VDC to BROWN wire:
- once for next pattern
- quick three times for FP#1
NOTE: This unit may not be factory-set at FP#1.
FP#
|
Flash Pattern
---|---
1| Double| [R65]| 11| Quint [SAE]| 21|
Triple| (Split)
2| Single| [2HZ]| 12| Mega| 22| Quad| (Split)
3| Triple| [2HZ]| 13| Giga| 23| Quint| (Split)
4| Quad| [2HZ]| 14| Ultra [SAE]| 24| Mega|
(Split)
5| Random| 15| Single-Quad| 25| Giga| (Split)
6| Steady/Cruise| 16| Single H/L| 26| Ultra| (Split)
7| Single| [SAE/CA13]| 17| Single-Triple-Quint| 27| Single-Quad| (Split)
8| Double| [SAE]| 18| Half-Steady-Half-Double (Split)| 28| Single H/L| (Split)
9| Triple| [SAE]| 19| Single (Split)| 29|
Single-Triple-Quint (Split)
10| Quad| [SAE]| 20| Double (Split)| 30|
Steady-Dim EF
- Actual approval will be based on the model purchased.
- Split = Top-half alternating Bottom-half.
For Simultaneous or Alternating Synchronization:
- Apply +VDC to WHITE and BROWN wires simultaneously to enter Grouping mode; the light head will display short (single or double) flashes:
- Single flash = Group1
- Double flash = Group2
- Remove BROWN wire from +VDC and momentarily apply to +VDC to change Group:
- Lightheads in the same Group will flash together.
- Group1 light heads and Group2 light heads will flash alternatingly.
- Save and exit Grouping Mode by disconnecting all power
- Connect BROWN wires of multiple light heads together for synchronization; all light heads should be set to the same Flash Pattern.
CAUTION
Overtightening the mounting screws could damage the light head and void the
warranty. Use an in-lb torque wrench, and tighten the mounting screws with the
suggested range of torque value: For #6 mounting screws – 6 to 7.8 in-lbs.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>