Cell2 B16 Cruise BB (3-Bolt Mount) User Manual

Cell2 B16 Cruise BB (3-Bolt Mount)


WIRING

• RED: To +VDC for Cruise Mode
• BLACK: To Chassis Ground (-)
• RED + WHITE: To +VDC for Warning Mode
• YELLOW: Flash patterns & Synchronization
  Connect YELLOW wires of all unit together for synchronization. (All unit should be set to the same Flash Pattern)

OPERATION

• For Flash Pattern Selection:
  While activating a warning mode, momentarily apply YELLOW wire to +VDC:

  • Once to next pattern
  • Quick three times to FP#1 (refer to Flash Pattern Chart)

• For Simultaneous or Alternating Synchronization:

1. Enter SETTING MODE by powering up with YELLOW and RED Note: Actual approval will be based on model ordered. wires simultaneously, then remove YELLOW wire from +VDC.  

The beacon will display short flashes:

  *  **Single flash =** Group 1
  *  **Double flash =** Group 2
2. Momentarily apply YELLOW wire to +VDC to change Groups:
  * Lightheads of the same Group will flash together.
  * Lightheads of the different Group will flash alternately.
3. Save and exit SETTING MODE by disconnecting all power.

INSTALLATION INSTRUCTION

1. Open beacon
   Twist dome counter clockwise  A , then lift dome to open.

2. Change Pattern
   While activating Warning Mode, momentarily push the RED BUTTON  1 to change to the next flash pattern. (see Flash Patterns chart)

3. Close beacon
   Twist and tighten the dome lens clockwise B to close.

4. Drill holes on the mounting surface for wire exit and mounting screws.

5. Secure the beacon onto the mounting surface with supplied screws.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>