HORNBY HOBBIES HM7000-Next 21TXS Bluetooth Module User Manual
- June 9, 2024
- HORNBY HOBBIES
Table of Contents
HORNBY HOBBIES HM7000-Next 21TXS Bluetooth Module
DESCRIPTION
The HM7000-Next 21TXS module is designed to comply with the FCC statement. FCC
ID is 2ACUF-700021TXS The host system using HM7000-Next 21TXS should have
label indicated it contain modular’s FCC ID : 2ACUF-700021TXS. This radio
module must not installed to co-locate and operating simultaneously with other
radios in host system, additional testing and equipment authorization should
be required to operating simultaneously with other radio. The H HM7000-Next
21TXS module is designed to comply with the ISED statement. The module ID is
12075A-HM700021TXS. The host system using HM7000-Next 21TXS, should have label
indicated it contain modular’s IC12075A-HM700021TXS. This radio module must
not installed to co-locate and operating simultaneously with other radios in
host system, additional testing and equipment authorization should be required
to operating simultaneously with other radio. List of applicable FCC rules:
The module complies with FCC Part 15.247.
Summarize the specific operational use conditions:
The module has been certified for Fix, Mobile applications. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.
Limited module procedures:
This module is limited to Hornby Corporation use ONLY. The module has no RF
shielding and will be installed in toy track car. which belong to signal
module Standard requires: Clear and specific instructions describing the
conditions, limitations and procedures for third parties to use and/or
integrate the module into a host device (see Comprehensive integration
instructions below).
Installation Notes:
- HM7000-21TXS Module Power supply range is DC 14V~16V, when you use HM7000- 21TXS Module design product, the power supply cannot exceed this range.
- Make sure the module pins correctly installed.
- Make sure that the module does not allow users to replace or demolition
- Any modifications to the module model HM7000-Next 21TXS may invalidate regulatory approvals or may necessitate notifications to the relevant regulatory authorities.
- OEM must inform iRobot Compliance of any changes which may require the Class I or Class II permissive changes for the FCC
Antennas
The module have an PCB antenna Information on test modes and additional testing requirements: When testing host product, the host manufacture should follow FCC KDB Publication 996369 D04 Module Integration Guide for testing the host products. The host manufacturer may operate their product during the measurements. In setting up the configurations, if the pairing and call box options for testing does not work, then the host product manufacturer should coordinate with the module manufacturer for access to test mode software.
Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) list on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed when contains digital circuity.
Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB
Publication 996369 D04 Module Integration Guide for testing the host products.
The host manufacturer may operate their product during the measurements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>