Maxxima MSL-125003 LED Under Cabinet Light Instruction Manual
- June 14, 2024
- Maxxima
Table of Contents
Maxxima MSL-125003 LED Under Cabinet Light
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry
CAUTIONS
- The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
- Supply conductors must at least be rated for 90°C/194°F.
- This fixture is designed for use with 120Vac, 50/60Hz only.
- This fixture is designed for use with Romex NM-B or BX cable
INSTALLATION INSTRUCTIONS
- Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel.
- Remove the plastic lens by squeezing the front of the lens in then lifting the lens out.
- Remove the light housing by squeezing the housing and lifting the housing out of the holding tabs.
- Select the appropriate knockout and remove it, Then install the proper connector. A BX connector is included.
- Install the fixture enclosure by using the provided wood screws using either the pre drilled holes or by using the keyhole slots. For reference, the distance between centers or the keyhole slots are shown in figure 2, figure 2a, and Figure 2b.
- Feed the supply wires through the previously installed connector and tighten the connector screws to ensure a snug fit.
- Holding the light housing close to the mounted fixture enclosure, connect the green wire to the green or bare copper wire using the provided wire nut, then connect the white wire to the white wire using the provided wire nut, and finally connect the black wire to the black wire using the provied wire nut.
- Install the light housing into the fixture enclosure by aligning the two backs then by squeezing the light housing ensure the leading edge locks into the clips on the leading edge of the fixture enclosure.
- Install the plastic lense by lining up the curved end with the front of the fixture, then press the back edge into the grove until it clicks into place.
- Select the desired CCT by moving the selector switch to the desired CCT shown in figure 3.
- Restore power to the fixture, the fixture can be turned on and off via the built in rocker switch.
- Installation is now complete.
5 YEAR WARRANTY
Maxima extends a 5 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
- info@maxximastyle.com
- С 866-MAXXIMA (629-9462)
- www.maxximastyle.com
- 125 Cabot Court Hauppauge, NY 11788
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>