HORNBY HOBBIES HM7000-Next18TXS Module User Manual
- June 9, 2024
- HORNBY HOBBIES
Table of Contents
HORNBY HOBBIES HM7000-Next18TXS Module
INTRODUCTIONS
The HM7000-Next18(8)TXS module is designed to comply with the FCC statement.
FCC ID is 2ACUF-7000818TX The host system using HM7000-Next18(8)TXS should
have label indicated it contain modular’s FCC ID : 2ACUF-7000818TX.
This radio module must not installed to co-locate and operating simultaneously
with other radios in host system, additional testing and equipment
authorization may be required to operating simultaneously with other radio.
The HM7000-Next18(8)TXS module is designed to comply with the ISED statement.
The module ID is 12075A-HM7000818TX. The host system using HM7000-Ni
ext18(8)TXS,
should have label indicated it contain modular’s IC : 12075A-HM7000818TX.
This radio module must not installed to co-locate and operating simultaneously
with other radios in host system, additional testing and equipment
authorization may be required to operating simultaneously with other radio.
List of applicable FCC rules:
The module complies with FCC Part 15.247
Summarize the specific operational use conditions:
The module has been certified for Fix, Mobile applications.
This transmitter must not be co‐located or operating in conjunction with any
other antenna or transmitter.
Limited module procedures:
This module is limited to Hornby Corporation use ONLY.
The module has no RF shielding and will be installed in toy track car.
which belong to signal module Standard requires:
Clear and specific instructions describing the conditions, limitations and
procedures for third‐ parties to use and/or integrate the module into a host
device (see Comprehensive integration instructions below).
Installation Notes
- HM7000-Next18(8)TXS Module Power supply range is DC 14V~16V, when you use HM7000-Next18(8)TXS Module design product, the power supply cannot exceed this range.
- Make sure the module pins correctly installed.
- Make sure that the module does not allow users to replace or demolition
- Any modifications to the module model HM7000-Next18(8)TXS may invalidate regulatory approvals or may necessitate notifications to the relevant regulatory authorities
- OEM must inform iRobot Compliance of any changes which may require the Class I or Class II permissive changes for the FCC.
Antennas
The module have an PCB antenna
Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB
Publication 996369 D04 Module Integration Guide for testing the host products.
The host manufacturer may operate their product during the measurements. In
setting up the configurations, if the pairing and call box options for testing
does not work, then the host product manufacturer should coordinate with the
module manufacturer for access to test mode software.
Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts
(FCC Part 15.247) list on the grant, and that the host product manufacturer is
responsible for compliance to any other FCC rules that apply to the host not
covered by the modular transmitter grant of certification. The final host
product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed when contains digital circuity.
Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB
Publication 996369 D04 Module Integration Guide for testing the host products.
The host manufacturer may operate their product during the measurements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>