Cell2 KUIPER-FIT Illuminated Centre 1516.6mm User Manual
- June 9, 2024
- Cell2
Table of Contents
Cell2 KUIPER-FIT Illuminated Centre 1516.6mm
Operation Manual
WIRING & FUNCTIONS (A1)
Proper installation of the product requires the installer to have a good
understanding of automotive electronics, systems and procedures. Different
applications may require different functions. For optimum efficiency, it is
highly recommended to determine, configure and test the required functions
prior to installation.
WIRING
- After the lightbar has been mounted, route the control cable into the vehicle to the switch panel/controller location.
- Connect the BLACK wire to the vehicle chassis ground.
- Connect the RED wire and WHITE wire to a fused switch for independent control.
FUNCTIONS
RED- WARNING MODE
Activate Warning Mode by applying +VDC to RED wire.
To change flash pattern, tap +VDC to YELLOW wire while in Warning Mode,
- Quick once to the next pattern.
- Quick 3 times to reset to FP#1 (default Flash Pattern).
WARNING
- FAULTY CONNECTIONS MAY CAUSE THE LIGHTBAR TO MALFUNCTION AND / OR RESET TO ITS DEFAULT SETTINGS.
- DO NOT USE A HIGH PRESSURE POWER WASHER TO CLEAN YOUR LIGHTBAR; THIS MAY DAMAGE YOUR LIGHTBAR AND VOID ITS WARRANTY.
FLASH PATTERN
1| Double [2Hz]| All| 17| Double [2Hz]| Split
2| Quad [2Hz]| All| 18| Quad [2Hz]| Split
3| Single [2Hz]| All| 19| Single [2Hz]| Split
4| Double (Corners) [2Hz]| All| 20| Double (Corners) [2Hz]| Split
5| Quad (Corners) [2Hz]| All| 21| Quad (Corners) [2Hz]| Split
6| Single (Corners) [2Hz]| All| 22| Single (Corners) [2Hz]| Split
7| Random| All| 23| Random| Split
8| Single| All| 24| Single| Split
9| Double| All| 25| Double| Split
10| Quad| All| 26| Quad| Split
11| Quint| All| 27| Quint| Split
12| Mega| All| 28| Mega| Split
13| Ultra| All| 29| Ultra| Split
14| Cruise| All| 30| Single-Quad| Split
15| Single-Quad| All| 31| Single H/L| Split
16| Single H/L| All|
- NOTE: Actual approval is based on the model ordered.
WHITE- ILLUMINATED CENTER SECTION
Activate Illuminated Center Section (ICS Lights) by applying +VDC to WHITE
wire.
NOTE: This wire will not activate any function if order the lightbar
without ICS lights in configuration.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>