Maxxima MEL-12350BW Outdoor Wall Light Installation Guide
- June 9, 2024
- Maxxima
Table of Contents
Maxxima MEL-12350BW Outdoor Wall Light
WIRING INSTRUCTIONS
- Ensure that power has been turned off by switching the circuit breaker or by removing the fuse from the fuse panel.
- If you are replacing an exisitng fixture, remove and disconnect the old fixture first.
- Expose the supply wires from the junction box.
- Position the supply wires with the white supply wire on one side of the junction box and the black supply wire on the other side.
- Thread the fixture mounting screws through the mounting bracket as shown in the illustration if required.
- Attach the mounting bracket to the junction box by allowing the junction box screws to pass through the large slots in the mounting bracket.
- Connect the junction box ground wire(green or bare) to the mounting bracket with the green hex-head ground screw by screwing it into the tapped hole in the mounting bracket marked “GND”.
- Connect the fixture ground wire(yellow w/ green stripe) to the junction box ground wire by using a wire connector.
- Connect the white wire from the fixture assembly to the white supply wire(neutral) from the post using a wire connector.
- Connect the black wire from the fixture assembly to the black supply wire(hot) from the post using a wire connector.
Note Strip 1-1/2” of insulation from the junction box ground wire (if insulated). Allow the stripped end to extend an extra 1” from the ground screw to enable a connection to the fixture ground wire using a wire connector.
FIXTURE MOUNTING INSTRUCTIONS
- After all connections are secure, carefully tuck the wires into the electrical junction box. No loose strands or loose connections should be present.
- Attach the fixture mounting plate to the fixture mounting screws on the mounting bracket. Make sure no wires are pinched or exposed. Tighten the cap screws or ball nuts to hold the fixture securly in place.
- To prevent moisture from entering the junction box and the fixtures mounting plate causing a short, apply a bead of clear caulk to outline the outside of the fixtures mounting plate where it meets the wall. Leave a small space at the bottom to allow any condensation or moisture to escape.
- The installation is now complete. Restore the electricity and check the operation of your lighting fixture.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
info@maxximastyle.com
866-MAXXIMA (629-9462)
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>