SYNCO V10 Small Diaphragm Condenser Microphone User Manual

: June 9, 2024
: SYNCO

Table of Contents

SYNCO V10 Small Diaphragm Condenser Microphone
Caring For Your SYNCO Product
Product Introduction
Operations
Specifications
Warranty Conditions
EU Declaration of Conformity
WEEE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SYNCO V10 Small Diaphragm Condenser Microphone

Dear customer, Thank you for purchasing our product. Please read the following instructions carefully before first use and keep this user manual for future reference. Pay particular attention to the safety instructions. If you have any questions or comments about the device, please contact the customer line.

Caring For Your SYNCO Product

Please keep the product in a dry, clean, dust-free environment.
Keep corrosive chemicals, liquids, and heat source away from the product to prevent mechanical damage.
Use only a soft and dry cloth cleaning the product.
Malfunction may be cause by dropping, impact of external force.
Do not attempt to disassemble the product. Doing so voids warranty.
Please have the product checked or repaired by authorized technicians if any malfunctions happened.
Failure to follow all the instructions may result in mechanical damage.
Warranty does not apply to human errors.

Product Introduction

High Frequency Boost
High-pass Filter
Front Attenuator

Operations

The Use of Wind Muff ****
The Use of Mic Clip
The 5/8” screw and 3/8” screw accessible mic clip is for attaching accessories like boom pole, mic stand.
The Use of Microphone
Connect the mic with the device via the XLR cable.

It is highly recommended that you set the recording level on your camera quite low, 1/2 or 1/3 of it at first, and tailor your levels to just about environment and recording device.

Specifications

Polar Pattern : Hyped-cardioid

Performance Parameter

Transducer Back Electret Condenser
Frequency Response 40Hz-18KHz
Signal/Noise 82dB (1KHz at 1Pa)
Maximum SPL 130dB (T.H.D 1% at 1KHz)
Sensitivity -32dB ± 3dB (1dB=1V/Pa at 1KHz)
Impedance 600Ω±20%
Equivalent Noise Level 14dB (A)
High Frequency Boost +3dB at 4~5Kz
High-pass Filter 150Hz
Front Attenuator -10dB
Output Connector XLR 3-Pin
Operating Voltage 12V-52 V (Phantom Power)
Operating Current 2mA
Material Metal
Dimensions (Φ x L) 23 x 145mm
Weight 94g

Warranty Conditions

A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you need repair or other services during the warranty period, contact the product seller directly, you must provide the original proof of purchase with the date of purchase. The following are considered to be a conflict with the warranty conditions, for which the claimed claim may not be recognized

Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation, and service of the product.
Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g., during transport, cleaning by inappropriate means, etc.).
Natural wear and aging of consumables or components during use (such as batteries, etc.).
Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.
If anyone has made modifications, modifications, alterations to the design or adaptation to change or extend the functions of the product compared to the purchased design or use of non-original components.

EU Declaration of Conformity

Identification data of the manufacturer’s / importer’s authorized representative: Importer: Alza.cz a.s. Registered office: Jankovcova 1522/53, Holešovice, 170 00 Prague 7 CIN: 27082440 Subject of the declaration: Title: Wireless system Model / Type: SYNCO V10 The above product has been tested in accordance with the standard(s) used to demonstrate compliance with the essential requirements laid down in the Directive(s): Directive No. 2014/30/EU Directive No. 2011/65/EU as amended 2015/863/EU

WEEE

This product must not be disposed of as normal household waste in accordance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE – 2012/19 / EU). Instead, it shall be returned to the place of purchase or handed over to a public collection point for the recyclable waste. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Contact your local authority or the nearest collection point for further details. Improper disposal of this type of waste may result in fines in accordance with national regulations.

www.alza.co.uk/kontakt
+44 (0)203 514 4411
Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Prague 7, www.alza.cz