SYNCO G2 Wireless Microphone with Display User Manual

June 3, 2024
SYNCO

SYNCO G2 Wireless Microphone with Display User Manual
SYNCO G2 Wireless Microphone with Display

Thank you for choosing SYNCO product.
Please read this manual carefully before use and follow all instructions mentioned herein.

Caring For Your SYNCO Product

  • Please keep the product in a dry, clean, dust-free environment.
  • Keep corrosive chemicals, liquids and heat source away from the product to prevent mechanics damage.
  • Use only a soft and dry cloth for cleaning the product.
  • Malfunction may be caused by dropping, impact of external force.
  • Do not attempt to disassemble the product. Doing so voids warranty.
  • Please have the product checked or repaired by authorized technicians if any malfunctions happened.
  • Failure to follow all the instructions may result in mechanics damage.
  • Warranty does not apply to human errors.

Package List

Package List

Product Instruction

Product Instruction

  1. External Mic Input
  2. USB-C Port
  3. Power(MUTE)
  4. Reset(Help with Eject Pin)
  5. Low Cut
  6. Pairing
  7. Built-in Mic
  8. Display Screen
  9. Pocket Clip

Product Instruction

  1. USB-C Port
  2. Power (MUTE)
  3. Reset(Help with Eject Pin)
  4. Gain Control
  5. Pairing
  6. 3.5mm Audio Output
  7. 3.5mm Monitoring Jack
  8. Display Screen
  9. Pocket Clip

Display Screen

Display Screen

Operations

TX

  1. Power/ Mute

Long Press 2s: turn on/off the system
Short Press: mute/unmute the microphone

  1. Charging

5V/2A;with USB-C Charging Cable
Please fully charge the product before use.

  1. External Mic Input

TRS Mic Only
(Note: When using a external mic, please insert it into the mic input properly.)

  1. Mic Windshield & Device Installation
    Operations

  2. Reset

  3. Low Cut
    Operations
    Short Press: 150Hz Low Cut On
    Short Press again: Low Cut Of

  4. Pairing
    Operations
    The system will pair automatically after power on.
    Manual pairing: long press the pairing button on the RX and TX for 3 seconds at the same time

RX

  1. Power/ Mute

Long Press 2s: turn on/off the system
Short Press: mute/unmute the microphone

  1. Charging

5V/2A;with USB-C Charging Cable
Please fully charge the product before use.

  1. Reset

  2. Gain Control

0-5 Level(0 → 3 → 6 → 9 → 12 → 15 → 0)
Each press increases gain by one level.

  1. Pairing
    Operations
    The system will pair automatically after power on.
    Manual pairing: long press the pairing button on the RX and TX for 3 seconds at the same time

  2. Audio Monitoring & Output Connection
    Operations

Setting The Recording Level Correctly

Camera devices generally have poor-quality, noisy preamps. In order to get the cleanest signals possible, it is highly recommended that you set the recording level on your camera quite low, 1/2 or 1/3 of it. G2 provides variable gain control, allowing you to tailor your levels to just about environment and recording device.

Adjust the recording level of inbuilt mics for SONY Camera (Take A7S Ⅱ for example)

Setting The Recording Level Correctly 

Adjust the recording level of inbuilt mics for Canon Camera (Take EOS 5D Mark Ⅳ for example)

Setting The Recording Level Correctly 

Adjust the recording level of inbuilt mics for Panasonic Camera (Take LUMIX GH5 for example)

Setting The Recording Level Correctly 

Specifications

TX Transmitter

Wireless Transmission Digital 2.4GHz
RF Frequency Band 2400-2483.5MHz
Working Distance 492ft/150m(LOS area), 164ft/50m(NLOS area)
Mounting Pocket Clip
Audio Input 1/8″ / 3.5mm TRS Mic Input
Audio Input Level 1V (0dBV)
RF Output Power <10mW
Power Requirements 3.3V-4.7V
Battery Type Built-in Lithium Battery, 400mAh
Battery Charging Time 1.5H
Battery Life 8H
Display TFT Screen
Dimensions 52×42×17mm
Material Plastic
Weight 39g

RX Receiver

Wireless Transmission Digital 2.4GHz
RF Frequency Band 2400-2483.5MHz
Approximate RF Sensitivity -81dBm
Working Distance 492ft/150m(LOS area), 164ft/50m(NLOS area)
Mounting Pocket Clip
Number of Audio Channels 1
Audio Output 1/8″ / 3.5mm TRS Mic Output
Gain 1/8″ / 3.5mm TRS Headphone Output 0-5 Level
Audio Output Level Line Out: 1V; Monitoring: 25-30mW
Power Requirements 3.3V-4.7V
Battery Type Built-in Lithium Battery, 400mAh
Battery Charging Time 1.5H
Battery Life 8H
Display TFT Screen
Dimensions 52×42×17mm
Material Plastic
Weight 39g

Microphone

Form Factor Built-in/External Mic
Sound Field Mono
Polar Pattern Omnidirectional
Frequency Range 50Hz-20KHz
Sensitivity -40dB (±3 dB, re 1V/Pa at 1KHz)
Maximum SPL 135dB SPL (at 1KHz)

Warranty

Warranty Period

Thank you for purchasing SYNCO products.

  1. Customers are entitled to free replacement or repair service in case of quality defect(s) found in the product under normal use within 30 days upon receipt of the product.
  2. Original SYNCO products are entitled to 12-month limited warranty service.
    The warranty period begins on the date of purchase of brand new, unused products by the first end-user.

Within the warranty period, if product defect or failure is attributable to material defection or technological problem, the defective product or defective part will be repaired or replaced without charge (service and materials fee).

Warranty Exclusions and Limitations

  • Faults resulted from inappropriate use of a product without following its operation specification
  • Artificial damage, e.g. crash, squeeze, scratch, or soaking
  • Modifications to a product by its user or a third party without prior written consent of SYNCO, e.g. replacement of element or circuit, label alteration
  • The code on product is inconsistent with that of warranty certificate, or the code on the product or warranty certificate is altered or torn off
  • All consumable accessory attached to a product, like cable, wind muff, battery
  • Faults as a result of force majeure, such as fire, flood, lightning, etc.

Warranty Claim Procedure

  • If failure or any problem occurs to your product after purchase, please contact a local agent for assistance, or you can always contact SYNCO’s customer service through email at support@syncoaudio.com.

  • Please retain your sales receipt and warranty certificate as proof of purchase.
    If any of these documents is missing, only sales return or chargeable service will be provided.

  • If the SYNCO product is out of the warranty coverage, the service and the parts cost will be charged.

WARRANTY CERTIFICATE

Please register your warranty. Meanwhile, you are welcomed to contact us via Email:support@syncoaudio.com
UINSFEORRMATION| Customer Name:
Phone Number:
Email:
Address:
SINAFLOERSMATION| Sales Date:
Model:
Product Code:
Dealer:
REPCAOIRRD| Service Date:
Technician:
Issue:

  • RESULT
  • Solved
  • Unsolved
  • Returned(Replaced)

Guangzhou Zhiying Technology Co., Ltd

Block 15th, No.200 Fangcun Avenue East, Liwan District, Guangzhou, China, 510000
support@syncoaudio.com
www.syncoaudio.com
https://www.facebook.com/syncomicrophones

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals