Indy LRM4 Housing – LED 4in Round Remodel L-Series Housing Instruction Manual

: June 9, 2024
: indy

Table of Contents

Indy LRM4 Housing – LED 4in Round Remodel L-Series Housing
IMPORTANT SAFETY INSTRUCTIONS
Installing the LRM Remodel series fixtures
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Indy LRM4 Housing – LED 4in Round Remodel L-Series Housing

Indy LRM4 Housing - LED 4in Round Remodel L-Series
Housing

IMPORTANT SAFETY INSTRUCTIONS

This fixture must be installed in accordance with local, federal codes and the NEC.IMPORTANT SAFETY INSTRUCTIONS

Read all instructions completely before beginning. Keep these instructions in safe place for future reference.
To reduce risk of fire and over-heating, make sure all connections are tight.
Turn off the electrical power before proceeding.

Installing the LRM Remodel series fixtures

IF REPLACING AN EXISTING FIXTURE: Before installing new fixture, remove existing fixture from ceiling by pushing fixture up through ceiling cut-out into plenum, orientate fixture to provide ac-cess to power supply and remove from fixture. Proceed to Step 2.

Step 1: Locate the center of the proposed opening on ceiling and using template (supplied with fixture) mark and accurately cut opening.
Step 2: Install the housing ring by sliding into the appropriately sized hole.
Step 3: With the housing ring in place, push clips (3) up and out until locked in place, securing housing ring snuggly against the ceiling.
Step 4: Pull the power supply through the opening. Electrical service must meet your local electrical code and supply wire insulation must be rated for at least 90° C.
Step 5: Wiring: Remove the junction box cover and the appropriate knock-out(s) and connect conduit to junction box with proper con-nector (not supplied). Connect black fixture wire to hot, white fixture wire to neutral and green wire to ground (make sure all connections are tight). Refer to wiring diagrams on following page to ensure proper wiring.
Step 6: Insert junction box assembly thru ceiling cut-out.
Step 7: 4″ Unit: Attach junction box to threaded stud using wing nut, securing assembly to housing ring. 6″ and 8″ Unit: Attach junction box to bracket using two (2) screws, securing assembly to housing ring (as shown).
Step 8: Push LED housing thru housing ring.
Step 9: Align slotted holes (3) of housing with screw holes on hous-ing ring and secure with 3 screws (supplied). Align edge of housing flush with ceiling before tighten screws. Make sure screws are fully engaged.
Step 10: Install trim, completing installation.